Geely EC718, EC718RV, EC715, EC715RV. Manual part - 8

 

  Главная      Geely     Geely Emgrand EC718, EC718RV, EC715, EC715RV. Workshop Manual year 2009

 

поиск по сайту            

 

 

 

 

 

 

 

 

 

 

 

содержание   ..  1  2  3  4  5  6  7  8  9    ..

 

Geely EC718, EC718RV, EC715, EC715RV. Manual part - 8

 

 

Engine Oil and Oil Filter Replacement

Make sure use the API grade engine oil, SJ grade engine oil or
above.

Engine Oil Viscosity

Note

Using engine oil other than the recommended ones will
damage the engine.

Engine oil viscosity (consistency) will affect the fuel economy
and  operations  in  cold  weather.  The  lower  the  engine  oil
viscosity, the better the vehicle's fuel economy and the better
cold  weather  performance.  In  high  temperatures,  engine  oil
with  higher  viscosity  must  be  used  to  achieve  the  desired
lubricating  effect.  Using  engine  oil  other  than  the
recommended ones will damage the engine.

Cooling System Service

Drain,  rinse  the  cooling  system  and  refill  the  new  engine
coolant. Refer to 

1.4.1.2

 

Recommended Oil and Lubricants

.

Fuel Filter Replacement

Every
Replace fuel filter every 30,000 km. The fuel filter is located at
the bottom of the rear end of the vehicle, close to the canister.

Air Cleaner Filter Replacement

Every
Replace  air  cleaner  filter  every  15,000  km.  Under  dusty
conditions, reduce the air filter replacement intervals.

Spark Plug Replacement

Use  only  genuine  Geely  parts  for  replacements.  Refer  to

1.4.2.2

 

Normal Driving Condition Service Schedule

.

Spark Plug Wire Replacement

Clean up the spark plug wire and inspect for burnt, cracking or
other  damage.  Make  sure  the  spark  plug  wire  is  installed
directly on the ignition system module and the spark plug. If
necessary, replace the spark plug wire.

Brake System Service

Inspect  the  disc  brake  pads  every  7,500  km  or  7  months.
Double-check the thickness of brake pads. If the brake pads

can not last until the next scheduled service, they should be
replaced.  Check  the  brake  fluid  tank  lid  vent  to  ensure  that
there is no dirt and the path is unblocked.

Differential Service

Inspect differential oil every 20,000 km or 12 months. Replace
differential oil every 40,000 km or 24 months.

Tire and Wheel Inspection and Tire Rotation

Inspect  whether  there  is  abnormal  tire  wear  or  damage.  To
make  tire  wear  evenly  and  to  extend  tire  life,  rotate  the  tire
positions.  If  there  is  abnormal  or  premature  wear,  wheel
alignment should be checked, and then check the wheels for
damage.

1.4.2.5 Tire Rotation Description

Note

If there is obviously uneven tire wear, the cause for this
should be eliminated.
When rotating the tires, it is recommended at the same
time check the tire and wheel assembly balancing.

1.  It  is  recommended  that  tire  rotation  be  carried  out  when
brake inspections are performed, as per the service schedule
outlined in the Owner's Handbook, or when: Difference in tread
depth between front and rear tires exceed 1.55 mm(0.08 in).

2.  Lifting  and  support  vehicles.  Refer  to 

1.3.1.1

 

Lifting  and

Jacking the Vehicle

.

Note

Note  the  location  of  each  tire  and  wheel  assembly  in
relation to the original position on the vehicle.

3. Remove the tire and wheel assembly. Refer to 

4.4.5.1

 

Wheel

Replacement

.

4.  Rotate  the  tire  and  wheel  assemblies  as  shown  in  the
following diagrams.

Note

For  'Non  Directional'  tires  carry  out  rotation  as  shown
below.

Vehicle Overview

Maintenance

1-23

FE01-0004b

Note

For 'Directional' tires carry out rotation as shown below.

1-24

Maintenance

Vehicle Overview

FE01-0020b

5. Install the tire and wheel assemblies. Refer to 

4.4.5.1

 

Wheel

Replacement

.

6. Remove the safety stands.

7. Lower the vehicle.

8. Check and adjust the tire inflation pressure.

Vehicle Overview

Maintenance

1-25

1.5 Service Information System

1.5.1 Description and Operation
1.5.1.1 Abbreviations Used In This Manual

Abbreviations

Description

ABS

Anti-lock Brake Control System

ACU

Airbag Control Module

BCM

Body Control Module

CAN

Controller Area Network

CKP

Crankshaft Position Sensor

CMP

Camshaft Position Sensor

DLC

Data Link Connector

ECM

Engine Control Module

ECT

Engine Coolant Temperature Sensor

EVAP

Evaporative Emission Canister Purge Solenoid Valve

HO

2

S

Heated Oxygen Sensor

IAC

Idle Air Control

IP (Cluster)

Instrument Panel Cluster

KS

Knock Sensor

TPS

Throttle Position Sensor

VSS

Vehicle Speed Sensor

PAID

Rear Park Aid Module

HVAC

Heating-Ventilation-Air Conditioning

HECU

Hydraulic Electronic Control Unit

IMMO

Engine Immobilizer Module

1-26

Service Information System

Vehicle Overview

 

 

 

 

 

 

 

 

 

 

содержание   ..  1  2  3  4  5  6  7  8  9    ..