|
|
Multifunction switch left-hand The Multifunction switch left-hand is on the left-hand side of the steering column and controls the following functions. Direction Indicators The direction indicators: •
operate when the ignition switch is in position II. •
are operated by moving the multifunction switch up or down until it latches in position, to •
can be operated while the multifunction switch is held against spring pressure before •
cancel automatically upon completion of a turn. The multifunction switch then returns to the An audible ticking and a flashing green warning lamp on the instrument cluster indicate that the direction indicators are operating. If an indicator bulb fails, the warning lamp and ticking operate at twice the normal rate and a message will appear on the instrument cluster message center. Side Lamps The Side Lamp function is operated by rotating the multifunction switch collar one position counter clockwise this will then activate the side lamps. Head Lamps The Head Lamp function is operated by rotating the multifunction switch collar two positions counter clockwise this will then activate the head lamps. Main Beam The Main Beam multifunction switch has one pull and one push position. Pulling the main beam multifunction switch toward the driver will cause the main beam lamps to flash. The main beam lamps can be flashed with the ignition on or off and will remain activated as long as the multifunction switch is held.
Pushing the multifunction switch away from the driver to the latch position will operate main beam lamps continuously if the head lamps are on. Auto Lamps The Auto Lamp function is operated by rotating the multifunction switch collar to the auto position. The head lamps will then operate automatically when the sunload sensor detects low light levels. Exit Delay The Exit Delay time can be varied by rotating the multifunction switch collar. Turning the collar clockwise will decrease the exit delay time and turning the collar counter clockwise will increase the exit delay time. The head lamps will stay for a set period of time ranging from 10 seconds to 2 minutes. |