349

Take out the rear trunk carpet, spare tire cover board and the rear trunk miscelleaneous box. Screw the

spare tire press plate assembly to take out the spare tire.

2. Installation

1

Clip the rear trunk inside trim onto the corresponding hole in the reserve order of the removal;

2

Install the right rear and left rear combination lamp access hole cover;

3

Install the right and left speaker grill to the rear partition inside trim with a cross screwdriver;

4

Install the rear partition inside trim to the vehicle body;

5

Install the high mounted stop lamp and the C- pillar upper inside trim.

(XV) Engine Hood Inside Trim

Engine Hood Inside Trim Diagram:

Engine Hood Inside Trim

1. Engine Hood Inside Trim

2. E-Clip

1. Removal

1

Open the engine hood and gas spring;

2

Remove the clip and remove the engine hood inside trim

2. Installation

1

Open the installed engine hood and gas spring;

2

Align the corresponding hole position in the the engine hood inside trim and press the clip in by hand.

 

 

 

2 

1

350

(XVI) Door

Front Door

Front Door Components:

1.Front Door

2.Front Door Hinge

3.Front Door Lock And Door Lock Actuator

4.Front Door Inner Trim Board 5.Power Window Motor

6.Power Window Actuator

7.Door Inside Handle

8.Protection Device

9.Door Outside Handle

10.Front Door Lock Hole

11.Front Door Glass

12.Door Window Regulator Run

13. Front Door Weatherstrip A

14.Front Door Lower Weatherstrip

15.Front Door  Weatherstrip B

16.Front Door Lock Striker

11 

16

10

8 

9 

3 

15

14 

13

4 

5 

6 

1 

12

2 

7 

351

1.Front Door Removal/Installation

(1)  Disconnect the negative (--) terminal cable from the battery.

(2)  Remove the front fender and remove the front door hinge.

(3) Remove the connector (See Notice on Removing the

Connector for detailed information)

(4) Remove front door hinges

(5) Remove the front door

(6) The installation is in the reverse order of the removal.

(7) Adjust the front door. (See Door Adjustment for detailed

information)

Front Door inner trim

1. Front Door Inner Trim Board Assembly

2.Front Door Inner Handle Assembly

3.Trim Board

4.Door Handle

5.Set Screw

1 

2 

4 

3 

5 

2 

Set Screw

352

1.The Front Door Inner Trim Board Removal/Installation

(1) Remove the set screw.

(2) Remove the front door inner trim board assembly.

(3) Disassemble the inner trim board assembly as required

(4) The installation is in the reverse order of the removal.

2.Front Door Glass Removal And Installation

(1) Lift the front door window glass, make the distance between

the front window glass top and rear door top weatherstrip

to be 130mm.

(2) Disconnect the negative (--) terminal cable from the battery.

(3) Remove the front door frame.

(4) Remove the hole cover.

(5) Remove the screw.

(6) Insert your hand into the front door component hole to lift

the front window glass.

(7) The installation is in the reverse order of the removal.

3.Glass Regulator Removal/Installation

(1) Loose the set screw: (See Figure)

Front 
Door 
Glass