|
|
Shaft Eyelet REMOVING 1. Using Shock Rod Clamping Tool (p/n 0644-277) to prevent damage to the shaft surface, place the shock 2. Heat the shaft eyelet with a torch to soften the Loctite. Fig. 9-551 AG260 NOTE: The eyelet must be heated up to 300° for the Loctite to soften. 3. Using a wrench, unscrew the eyelet from the shaft. Fig. 9-552 AG261 INSTALLING 1. Clean shaft threads and eyelet threads. Apply red Loctite to both threads and tighten securely. Ski Shocks Bottom-Out Bumper Bottom-out bumper can be replaced by removing shock Pressurizing Rebuildable Shocks To pressurize the gas shock absorber, a regulator system Fig. 9-553 AG271 ! WARNING Never have a nitrogen bottle in the shop without ! WARNING Always rotate the regulator T-handle to its loose NOTE: Before inserting the needle into the bladder, lubricate the needle with light oil to make 1. Insert the Shock Inflation Needle (p/n 0644-158) into the shock bladder; then open the valve on the 9-176 |