Toyota Sequoia (2005). Manual - part 875

Perform any of the following and the system will go to disarmed state (B):

 Turn the key from IG to OFF and remove the key from the ignition, open the driver’s door.

Disarmed state (A)

Perform any of the following and the system
will return to disarmed state (A):

 Push the unlock switch on the transmitter.

 Put the key in the key cylinder.

 Reconnect the battery.

 Turn the ignition from OFF to ON.

 Unlock any of the doors or back door with

the key.

Disarmed state (B)

Perform the following and the system will go 
to arming preparation:

 Close all the doors, hood and 

   back door.

Perform any of the following
and the system
will return to disarmed state
(B):

 Open any of the doors, the

hood or the back door.

Arming preparation

Perform the following and the 
system will go to armed state:

 Allow 30 seconds to elapse

with all the doors, hood and
back door closed.

Perform any of the following and
the system
will return to disarmed state (A):

 Push the unlock switch on the

transmitter.

 Put the key in the ignition.

 Reconnect the battery.

 Turn the ignition from OFF to

ON.

 Unlock any of the doors or back

door with the key.

–

BODY ELECTRICAL

THEFT DETERRENT SYSTEM

BE–85

3489

3.

PASSIVE ARMING MODE



This mode can be switched by the C–BEST customizing
function (See page 

DI–1684

).



All modes are initially set to active when shipped from fac-
tory (no passive mode).

Perform the following and the system will return 
to armed state:

 Allow the alarm sounding period to pass.

Alarm sounding

Perform any of the following and the system will
return to disarmed state (A):

 Push the unlock switch on the transmitter.

 Put the key in the key cylinder and turn it ON.

 Unlock any of the doors or the back door 

with the key.

Perform any of the following and the system will
return to disarmed state (A): *

 Push the unlock switch on the transmitter.

 Put the key in the key cylinder and turn it ON.

 Unlock any of the doors or the back door 

with the key.

Armed state

Perform and/or detect any of the following 
and the system will go on to alarm sounding:

 Open any of the doors or the back door and 

allow the entry delay time to pass.

 Open the hood.

 Reconnect the battery.

 Ignition switch is connected directly.

 Broken window glass.

BE–86

–

BODY ELECTRICAL

THEFT DETERRENT SYSTEM

3490

Door

Indicator

Alarming output

System condition

Armed state

Alarm
sounding

Entry delay time

Close

Open

ON

OFF

ON

OFF

–

BODY ELECTRICAL

THEFT DETERRENT SYSTEM

BE–87

3491

HINT:
If any door is opened in the armed state, entry delay will occur
for 14 seconds.
During this time, the mode transfers to disarmed state if the
condition  * is met.
When the condition is not met, the system judges that theft oc-
curs and transfers to the alarm sounding state.

BE–88

–

BODY ELECTRICAL

THEFT DETERRENT SYSTEM

3492

Indicator light output:

Condition

Indicator light

Disarmed state

OFF

Arming preparation

ON

Armed state

(Entry delay time)

OFF

(ON)

Alarm sounding

ON

HINT:
Even in the disarmed state, the indicator light blinks. (Due to the
signal output from the immobilizer system). The indicator al-
ways blinks receiving the signal from the immobilizer system
any time in the arming condition.

Blinking frequency:
 0.2 seconds (ON)
 1.8 seconds (OFF)
(a)

Transfer to active mode:
In each passive mode, when ”disarmed state of active
mode 

→

 arming preparation transfer condition” is met, the

active mode transfers to each condition. In this case, ac-
tive mode continues till it becomes disarmed state.

Passive mode when transfer condition is

met.

Active mode transfer condition

Disarmed state

Arming preparation condition

Arming preparation condition

Arming preparation condition

Armed state

(During entry delay time)

Arming condition

(After alarming time has elapsed, arming

condition)

Alarm sounding

After alarming time has elapsed, arming

condition

(b)

Answer back:
The buzzer and taillights respond as answer back under
the following conditions.
(1)

When the system is set:
Arming preparation is set from disarmed state using
the wireless door lock, the buzzer and taillights.

(2)

When the system is released:
Disarmed state is set from either arming prepara-
tion, armed state or alarm sounding using the wire-
less door lock, the buzzer and taillights.

4.

PANIC ALARM CONTROL

(a)

The panic alarm control makes it possible for you to volun-
tarily set off the panic alarm by pressing the PANIC switch
on the wireless transmitter.  However, this control oper-
ates independently from the alarm control by the theft de-
terrent system (switched to the alarm sounding state from
the armed state).