|
|
front seats with electric controls ........................................(current page) 1.18 ENG_UD6500_2 Sièges avant à à commandes électriques (X91 - B91 - K91 - Renault) ENG_NU_936-5_BK91_Renault_1 Switch 3 is used for adjusting the seat- back and switch 4 is used for adjusting the seat squab. On equipped vehicles, buttons 2 are used to store the chosen driving posi- tion (refer to the following page). Adjusting the seat squab: – To move the seat forwards or back Move switch 4 forwards or back- wards. – To raise or lower the rear of the seat base Move the rear of switch 4 upwards or downwards. – To raise or lower the front of the seat base Move the front of switch 4 upwards or downwards. Adjusting the lumbar support on the driver’s seat: Lower handle 5 to increase the support and lift to decrease it. Adjusting the seatback: To tilt the seatback, move the top of switch 3 forwards or backwards. Heated seats (depending on vehicle) With the engine running, turn control 1 to either position 1, 2 or 3 (depending on the temperature required). An in- dicator light on the instrument panel lights up once the front seat heating system is operating. The system, which has a thermostat, decides whether or not the heating is needed. fRONT sEATs WITH ELEcTRIc cONTROL 1 4 3 2 5 For safety reasons, carry out any adjustments when the vehicle is not being driven. We would advise you not to recline the seatbacks too far to ensure that the effectiveness of the seat belts is not reduced. floor (area in front of driver) as such objects may slide under the pedal during braking manoeuvres, thus obstructing its use. |