|
|
AV U1303 LED POWER SUPPLY VOLT AV-539 < DTC/CIRCUIT DIAGNOSIS > [PREMIUM AUDIO WITH NAVIGATION] C D E F G H I J K L M B A O P Is the inspection result normal? YES >> Replace LH side camera. Refer to AV-632, "Removal and Installation" . NO >> Replace around view monitor control unit. Refer to AV-629, "Removal and Installation" 4. CHECK RH SIDE CAMERA POWER SUPPLY AND POWER SUPPLY GROUND CIRCUIT CONTINUITY 1. Turn ignition switch OFF. 2. Disconnect around view monitor control unit connector M96 and RH side camera connector D128. 3. Check continuity between around view monitor control unit connector M96 and RH side camera connector D128. 4. Check continuity between around view monitor control unit connector M96 and ground. Is the inspection result normal? YES >> GO TO 5. NO >> Repair or replace harness or connectors. 5. CHECK AROUND VIEW MONITOR CONTROL UNIT VOLTAGE 1. Connect around view monitor control unit connector M96 and RH side camera connector D128. 2. Turn ignition switch ON. 3. Check the voltage between around the terminals of view monitor control unit connector M96. Is the inspection result normal? YES >> Replace RH side camera. Refer to AV-632, "Removal and Installation" NO >> Replace around view monitor control unit. Refer to AV-629, "Removal and Installation" Around view monitor control unit M96 Condition Voltage (Approx.) (+) ( −) Terminal Terminal 30 29 CAMERA switch is ON or shift position is R. 6.0 V Around view monitor control unit RH side camera Continuity Connector Terminal Connector Terminal M96 34 D128 6 Yes 33 18 Around view monitor control unit Ground Continuity Connector Terminal M96 33 — No Around view monitor control unit M96 Condition Voltage (Approx.) (+) ( −) Terminal Terminal 34 33 CAMERA switch is ON or shift position is R. 6.0 V |