|
|
ADP-140 < DTC/CIRCUIT DIAGNOSIS > SLIDING MOTOR SLIDING MOTOR Description INFOID:0000000009176644 • The sliding motor LH is installed to the seat frame. • The sliding motor LH is activated with the driver seat control unit. • The seat is slid forward/backward by changing the rotation direction of sliding motor LH. Component Function Check INFOID:0000000009176645 1. CHECK FUNCTION 1. Select “SEAT SLIDE” in “ACTIVE TEST” mode with CONSULT. 2. Check the sliding motor LH operation. Is the operation of relevant parts normal? YES >> Inspection End. NO >> Perform diagnosis procedure. Refer to ADP-140, "Diagnosis Procedure" Diagnosis Procedure INFOID:0000000009176646 Regarding Wiring Diagram information, refer to ADP-55, "WITH AROUND VIEW MONITOR : Wiring Diagram" or ADP-40, "WITHOUT AROUND VIEW MONITOR : Wiring Diagram" . 1. CHECK SLIDING MOTOR LH POWER SUPPLY 1. Turn the ignition switch to ACC. 2. Perform “ACTIVE TEST” (“SEAT SLIDE“) with CONSULT. 3. Check voltage between driver seat control unit harness connector and ground. Is the inspection result normal? YES >> Replace sliding motor LH. Refer to SE-86, "Removal and Installation" NO >> GO TO 2. 2. CHECK SLIDING MOTOR LH CIRCUIT 1. Turn ignition switch OFF. 2. Disconnect driver seat control unit and sliding motor LH. 3. Check continuity between driver seat control unit harness connector and sliding motor LH harness con- nector. Test Item Description SEAT SLIDE OFF Seat sliding Stop FR Forward RR Backward (+) (-) Condition Voltage (V) (Approx.) Driver seat control unit Connector Terminal B210 36 Ground SEAT OFF 0 FR (forward) 0 RR (backward) Battery voltage 44 OFF 0 FR (forward) Battery voltage RR (backward) 0 |