Index Land Rover Land Rover Frelander 2 - service repair manual 2006-2010 year
|
|
General Information - How To Use This Manual Description and Operation Copyright Statement Copyright.© Land Rover Ltd., 2006 All rights reserved. No part of this publication may be reproduced, stored in a retrieval system or transmitted in any form, How To Use This Manual This manual covers all aspects necessary in order to service the vehicle effectively. The manual is structured into five main sections, General Information, Chassis, Powertrain, Electrical and Body and Paint Each of the five main sections contain sub-sections dealing with items which form a part of that specific system. Pages at the start of the manual list all sections available. Each section has a contents list detailing, where applicable, Where components need to be removed or disassembled in sequence, each operation in the sequence will be identified All left-hand and right-hand references to the vehicle are taken from a position sitting in the driver seat looking forward. All left-hand and right-hand references to the engine are taken from a position at the flywheel looking towards the front Inspection and Verification Visual Inspection Charts, Symptom Charts and other information charts (such as diagnostic routines) or supplement test Symptom Chart The symptom chart indicates symptoms, sources and actions to address a condition. Pinpoint Tests For electrical systems, pinpoint test steps are used to identify the source of a concern in a logical, step-by-step manner. The CONDITIONS column is used exclusively for graphics and icons (with or without captions) and the DETAILS/RESULTS The boxed numbers indicate the order in which the described action is to be carried out. Component Tests A component test is used when a component is tested in multiple pinpoint tests, or if a procedure is too complicated to be Graphics Test graphics show the measurement or test to be carried out in a test step. A representative tester graphic is used for voltmeters and ohmmeters. If multiple measurements are made in a single graphic, the test leads are drawn with a solid line until the test lead splits Breakout box type testers are represented by a double circle test pin. Test pins are labelled with the pin number. • NOTE: Dimensions quoted are to design engineering specifications with service limits quoted, where applicable. Workshop Manual Organization The five main sections, together with the areas which they cover are given below: Section 1 - General Information. Sub-section numbers appear after the initial section number, for example, Section 412-01 covers Climate Control, which is In the number given above, the first digit of the number '4' indicates the section i.e. Electrical. The second and third digits '12' of the number indicate the vehicle system i.e. Climate Control. |