|
|
ENGINE - V8 OVERHAUL 12-2-77 Reassembly 1. Clean camshaft bearings in block. oil. 6. Fit camshaft, take care not to damage camshaft bearings. 7. Lubricate thrust plate and mating face with clean engine oil. 8. Position thrust plate, fit and tighten bolts to 22 Nm (17 lbf.ft). 9. Fit timing chain and gears. 10. Immerse tappets in engine oil. Before fitting, pump the inner sleeve of tappet several times 11. Clean tappet bores. engine oil. 13. Fit tappets. engine oil. 16. Fit push rods. valves with clean engine oil. 20. Fit rocker shafts and engage push rods. Ensure rockers shafts are fitted to the correct cylinder 21. Fit and progressively tighten rocker shaft bolts to 40 Nm (30 lbf.ft). 22. Fit inlet manifold gasket. |