-> No
Suspect an internal fault with the Seat Climate Assembly. Replace as required, refer to the
Warranty Policy and Procedures manual (section B1.2). Prior to installing a new component.
Follow the link below to check operation of the Driver or Front Passenger Seat Cushion
Climate Assembly. GO to Pinpoint Test G1014305t18.
PINPOINT TEST G1014305p7 : Heating
And Cooling - Noisy Operation
G1014305t23 : Check For Stored DTC
1. Check the Climate Controlled Seat Module for stored DTC's.
•
Are there any stored DTC's?
-> Yes
For information on stored DTC's refer to the information in the Climate Controlled Seat
Module DTC index.
-> No
GO to Pinpoint Test G1014305t24.
G1014305t24 : Driver Or Front Passenger Seat Backrest
Climate Assembly - Noise
1. There is a known issue which effects a limited number of vehicles where under acceleration
of the vehicle the occupant of seat can deform the suspension mat (snake wire) which then
presses on the casing of the seat backrest climate assembly, this causes the casing to distort
and the noise issue to occur. If contact has occurred there will be a witness mark on the
casing. Carry out visual inspection of the seat backrest climate assembly that has been
identified as noisy by the customer.
•
Is there a witness mark on the casing?
-> Yes
Contact the local in market support for further information.
-> No
GO to Pinpoint Test G1014305t25.
G1014305t25 : Driver Or Front Passenger Seat Climate
Assembly - Noise 2