-> No
GO to Pinpoint Test G1014305t3.
G1014305t2 : Check front seat forward-rearward seat
motor drive bar
1. Check front seat drive bar for correct installation and condition
•
Is the front seat drive bar correctly installed and in a serviceable condition?
-> Yes
Re-check for correct front seat forward-rearward movement. Remove seat to allow for further
investigation if required.
-> No
Correctly install front seat forward-rearward seat motor drive bar, or replace if required.
G1014305t3 : Check front seat forward-rearward seat
motor
1. Set ignition status to 'OFF'. 2. Disconnect front seat forward-rearward seat motor
connector. 3. NOTE:
It may be that the seat has been driven to the limit of travel along the relevant axis, and
when the link harness is connected, the seat will remain in the same position. If this is the
case, a jolt may be felt from the motor. To confirm the motor operation, swap the link
harness to alternate motor pin connections and the seat should travel in the opposite
direction.
Using a locally made fused link harness and power supply, connect power and ground to
forward-rearward seat motor.
Battery positive terminal
Battery negative terminal
forward-rearward seat motor pin 1 forward-rearward seat motor pin 2
•
Does the motor operate?
-> Yes
Using manufacturer approved diagnostic system, check for related Diagnostic Trouble Codes
(DTCs) and carry out the repair operations specified. Alternatively, refer to the electrical
circuit diagrams and check front seat forward-rearward seat motor circuits.
-> No
Replace front seat forward-rearward seat motor. Refer to relevant section of workshop
manual.