PINPOINT TEST G1014305p4 : Front seat
height, tilt and/or seat extension motor
movement not functioning
G1014305t12 : Check front seat height, tilt or extension
motor
1. Set ignition status to ' OFF'. 2. Disconnect front seat height, tilt or extension motor
connector. 3. NOTE:
It may be that the seat has been driven to the limit of travel along the relevant axis, and
when the link harness is connected, the seat will remain in the same position. If this is the
case, a jolt may be felt from the motor. To confirm the motor operation, swap the link
harness to alternate motor pin connections and the seat should travel in the opposite
direction.
Using a locally made fused link harness and power supply, connect power and ground to
relevant motor.
Battery positive terminal Battery negative terminal
motor pin 1
motor pin 2
•
Does the motor operate?
-> Yes
Using manufacturer approved diagnostic system, check for related Diagnostic Trouble Codes
(DTCs) and carry out the repair operations specified. Alternatively, refer to the electrical
circuit diagrams and check relevant motor circuits.
-> No
Replace the relevant motor. Refer to relevant section of workshop manual.
PINPOINT TEST G1014305p5 : Front seat
height, tilt and/or extension movement noisy
G1014305t13 : Compare the height, tilt or extension
movement noise with the other front seat
1.
WARNING: Before work is carried out, make the air bag supplemental restraint
system safe. For additional information, refer to Standard Workshop Practices section
of workshop manual.