|
|
|
Content .. 1255 1256 1257 1258 ..
match what was expected)
mismatch with the rear
with the rear electronic module REM
B2141 NVM Configuration Failure
•
(LED flash 22)
Carry out any pinpoint tests associated with this DTC using the manufacturer approved diagnostic system. Enter vehicle id into instrument cluster (Enable PCM ID transfer) using the manufacturer approved diagnostic system.
B2143 NVM Memory Failure
•
Instrument cluster,
Carry out any pinpoint tests associated with this DTC using the manufacturer approved diagnostic system. Suspect instrument cluster internal failure. Clear DTC carry out battery reset, if DTC returns suspect instrument cluster internal failure, check and replace as required, refer to the new module installation note at the top of the DTC Index
B2162 Data Mismatch #2 (receive data does not match what was expected)
•
Electronic steering
Enable Electronic steering column lock ID transfer using the manufacturer approved diagnostic system.
B2329 Column Reach Feedback Potentiometer Circuit Open
•
Instrument cluster,
Carry out any pinpoint tests associated with this DTC using the manufacturer approved diagnostic system. Refer to electrical circuit diagrams, notes and check instrument cluster, steering column movement assembly, telescope position feedback circuit for open circuit or short to ground
B2330 Column Reach Feedback Potentiometer Circuit Short to Power
•
Instrument cluster, Carry out any pinpoint tests associated with this DTC using the manufacturer approved diagnostic system. Refer to electrical circuit diagrams, notes and check |