|
|
6C-10 ENGINE FUEL FUEL FILTER CARTRIDGE Removal • Remove the cartridge using a filter wrench. Filter wrench: 5-8840-0253-0 (J-22700) Installation • Clean the cartridge mounting surface of filter body so that the cartridge can be securely. • To facilitate bleeding, fill the new cartridge with light oil. • Tighten the cartridge until O-ring comes in contact with the sealing, taking care not to spill the light oil. • Retighten 1/3 — 2/3 using a filter wrench. Filter wrench: 5-8840-0253-0 (J-22700) Air Bleeding • Operate priming pump to send the air in the fuel system to the injection pump. • Loosen injection pump bleeding plug, and operate the priming pump until no bubble is made. • Tighten the bleeding plug. onds or less, repeat the bleeding steps. • Make sure of no fuel leakage, and tighten the prim- ing pump. Draining • When the water in the sedimentor reaches the specified volume, warning light is actuated. • Set a vinyl hose over the drain plug. eral times. • After draining, tighten the drain plug. • Operate the priming pump several times to check for fuel leakage. • Check and see the warning light is off. N6A3399E N6A3012E |