Honda Accord Hybrid (2019 year). Instruction - part 7

96

uu

Indicators

u

In

strum

e

nt Pa

nel

Indicator

Name

On/Blinking

Explanation

Message

Low Tire 
Pressure/TPMS 
Indicator

• May come on briefly if the power 

mode is set to ON and the vehicle is 
not moved within 45 seconds, to 
indicate the calibration process is 
not yet complete.

• Comes on and stays on when:

- One or more tires’ pressures are 

determined to be significantly low.

- The system has not been 

calibrated.

• Comes on while driving - Stop in a safe 

place, check tire pressures, and inflate the 
tire(s) if necessary.

• Stays on after the tires are inflated to 

the recommended pressures - The 
system needs to be calibrated.

2 TPMS Calibration P. 480

• Blinks for about one minute, and 

then stays on if there is a problem 
with the TPMS.

• Blinks and remains on - Have your 

vehicle checked by a dealer.

• Comes on if the TPMS is 

deactivated temporarily after the 
12-volt battery has been 
disconnected, then re-connected.

• Drive a short distance at more than 12 

mph (20 km/h). The indicator should go 
off. If it does not, have your vehicle 
checked by a dealer.

97

uu

Indicators

u

Continued

In

strum

e

nt Pa

nel

Indicator

Name

On/Blinking

Explanation

Message

Turn Signal and 
Hazard 
Warning 
Indicators

• Blinks when you operate the turn 

signal lever.

• Blinks along with all turn signals if 

you press the hazard warning 
button.

• Does not blink or blinks rapidly - A 

turn signal light bulb has blown. Change 
the bulb immediately.

2 Replacing Light Bulbs P. 593, 594 

—

High Beam 
Indicator

• Comes on when the high beam 

headlights are on.

—

—

Lights On 
Indicator

• Comes on whenever the light 

switch is on, or in AUTO when the 
exterior lights are on.

• If you set the power mode to VEHICLE OFF 

while the lights are on, a chime sounds 
when the driver’s door is opened.

—

Fog Light 
Indicator

*

• Comes on when the fog lights are 

on.

—

—

* Not available on all models

98

uu

Indicators

u

In

strum

e

nt Pa

nel

*1:Canadian models only: Apply and hold the brake pedal before selecting the ON mode.
*2:Canadian models

Indicator

Name

On/Blinking

Explanation

Message

Immobilizer 
System 
Indicator

• Blinks if the immobilizer system 

cannot recognize the key 
information.

• Blinks - You cannot start the power 

system. Set the power mode to VEHICLE 
OFF

*1

, then select the ON mode again.

• Repeatedly blinks - The system may be 

malfunctioning. Have your vehicle 
checked by a dealer.

• Do not attempt to alter this system or add 

other devices to it. Electrical problems can 
occur.

Security System 
Alarm Indicator

• Blinks when the security system 

alarm has been set.

2 Security System Alarm P. 181

—

Indicator

*2

*2

Indicator

99

uu

Indicators

u

Continued

In

strum

e

nt Pa

nel

Indicator

Name

On/Blinking

Explanation

Message

System 
Message 
Indicator

• Comes on along with a beep when 

a problem is detected. A system 
message on the driver information 
interface appears at the same time.

• While the indicator is on, press the 

 

(home) button to see the message again.

2 Accessing contents in the main 

display P. 135

• Refer to the Indicators information in this 

chapter when a system message appears 
on the driver information interface. Take 
the appropriate action for the message.

• The driver information interface does not 

return to the normal screen unless the 
warning is canceled, or the left selector 
wheel is pressed.

—

100

uu

Indicators

u

In

strum

e

nt Pa

nel

*1:Models without adaptive damper system
*2:Models with adaptive damper system

Indicator

Name

On/Blinking

Explanation

Message

ECON Mode 
Indicator

• Comes on when you press the 

ECON button.

2 ECON Button P. 475

*1

*2

101

uu

Indicators

u

Continued

In

strum

e

nt Pa

nel

*1:Models without adaptive damper system
*2:Models with adaptive damper system

Indicator

Name

On/Blinking

Explanation

Message

SPORT Mode 
Indicator

• Comes on when you press the 

SPORT button.

• The ambient meter remains lit up in 

red as long as sport mode is on.

2 SPORT Mode P. 471

*1

*2

102

uu

Indicators

u

In

strum

e

nt Pa

nel

Indicator

Name

On/Blinking

Explanation

Message

Adaptive Cruise 
Control (ACC) 
with Low Speed 
Follow (LSF) 
Indicator 
(Amber)

• Comes on if there is a problem with 

ACC with LSF.

• Comes on while driving - Have your 

vehicle checked by a dealer.

• Indicator comes on temporarily 

when the Maximum Load Limit is 
exceeded.

• ACC with LSF has been 

automatically canceled.

• Make sure the total load is within the 

Maximum Load Limit.

2 Maximum Load Limit P. 455

• Comes on if the ACC with LSF is 

deactivated temporarily after the 
12-volt battery has been 
disconnected, then re-connected.

• Drive a short distance at more than 12 

mph (20 km/h). The indicator should go 
off. If it does not, have your vehicle 
checked by a dealer.

Adaptive Cruise 
Control (ACC) 
with Low Speed 
Follow (LSF) 
Indicator 
(Green)

• Comes on when you press the 

MAIN button.

2 Adaptive Cruise Control (ACC) with 

Low Speed Follow (LSF) P. 503

—

103

uu

Indicators

u

Continued

In

strum

e

nt Pa

nel

Indicator

Name

On/Blinking

Explanation

Message

Lane Keeping 
Assist System 
(LKAS) 
Indicator 
(Amber)

• Comes on if there is a problem with 

the LKAS.

• Stays on constantly - Have your vehicle 

checked by a dealer.

Lane Keeping 
Assist System 
(LKAS) 
Indicator 
(Green)

• Comes on when you press the 

MAIN button.

2 Lane Keeping Assist System (LKAS) 

P. 519

—

104

uu

Indicators

u

In

strum

e

nt Pa

nel

Indicator

Name

On/Blinking

Explanation

Message

Safety Support 
Indicator 
(Amber)

• Comes on if there is a problem with 

RDM, CMBS

TM

, or Blind spot 

information System

*

.

• Stays on constantly - Have your vehicle 

checked by a dealer.

• Indicator may come on temporarily 

when the Maximum Load Limit is 
exceeded.

• Make sure the total load is within the 

Maximum Load Limit.

2 Maximum Load Limit P. 455

• Comes on if the RDM and CMBS

TM

 

are deactivated temporarily after 
the 12-volt battery has been 
disconnected and then re-
connected.

• Drive a short distance at more than 12 

mph (20 km/h). The indicator should go 
off. If it does not, have your vehicle 
checked by a dealer.

* Not available on all models

105

uu

Indicators

u

Continued

In

strum

e

nt Pa

nel

Indicator

Name

On/Blinking

Explanation

Message

Safety Support 
Indicator 
(Amber)

• Comes on when RDM and/or 

CMBS

TM

 shuts itself off.

• Indicator may come on temporarily when 

passing through an enclosed space, such 
as tunnel.

• The area around the radar sensor is 

blocked by dirt, mud, etc. Stop your 
vehicle in a safe place and wipe the debris 
off with a soft cloth.

• Have your vehicle checked by a dealer if 

the indicator does not go off even after 
you have cleaned the radar sensor.

2 Collision Mitigation Braking 

System

TM

 (CMBS

TM

) P. 494

• Stays on - The temperature inside the 

camera is too high.
Use the climate control system to cool 
down the camera.
The system activates when the 
temperature inside the camera cools 
down.

2 Front Sensor Camera P. 537

106

uu

Indicators

u

In

strum

e

nt Pa

nel

Indicator

Name

On/Blinking

Explanation

Message

Safety Support 
Indicator 
(Amber)

• Comes on when RDM and/or 

CMBS

TM

 shuts itself off.

• Stays on - The area around the camera is 

blocked by dirt, mud, etc. Stop your 
vehicle in a safe place and wipe the debris 
off with a soft cloth.

• Have your vehicle checked by a dealer if 

the indicator and message are still 
displayed even after you have cleaned the 
area around the camera.

2 Front Sensor Camera P. 537

• Comes on when mud, snow, or ice 

has accumulated in the vicinity of 
the Blind spot information System 
sensor.

• Comes on while driving - Something 

may be interfering with the Blind spot 
information System sensor. Check the 
vicinity of the Blind spot information 
System sensor and remove any obstacles. 

2 Blind spot information System

*

 

P. 485

Models with Blind spot information 
System

* Not available on all models

107

uu

Indicators

u

In

strum

e

nt Pa

nel

Indicator

Name

On/Blinking

Explanation

Message

Safety Support 
Indicator 
(Green/Gray)

• Lights up in green when RDM, 

CMBS

TM

, and Blind spot 

information System

*

 are on.

• Lights up in green and gray when 

RDM, CMBS

TM

, or Blind spot 

information System

*

 or any two of 

these systems are off.

• Lights up in gray when RDM, 

CMBS

TM

, and Blind spot 

information System

*

 are off.

2 RDM On and Off P. 529
2 CMBS

TM

 On and Off P. 497

2 Blind spot information system on 

and off P. 487

* Not available on all models

108

uu

Indicators

u

Driver Information Interface Warning and Information Messages

In

strum

e

nt Pa

nel

Driver Information Interface Warning and Information Messages

The following messages appear only on the driver information interface. Press the 

 (home) button, select Warnings, then press the left 

selector wheel to see the message again with the system message indicator on.

Message

Condition

Explanation

• Appears when the vehicle is no longer able to run 

due to a malfunction.

• Immediately stop in a safe place.
• Have your vehicle checked by a dealer immediately.

• Appears when there is a risk that the vehicle will 

move unexpectedly after you have stopped due to a 
malfunction with the vehicle.

• While the vehicle is stopped, apply the parking brake.
• Have your vehicle checked by a dealer.

• Appears when you set the power mode to ON again 

and the vehicle is able to run.

2 Turning on the Power P. 458

109

uu

Indicators

u

Driver Information Interface Warning and Information Messages

Continued

In

strum

e

nt Pa

nel

Message

Condition

Explanation

• Appears if any door or the trunk is not completely 

closed.

• Appears if any door or the trunk is opened while 

driving. The beeper sounds.

• Disappears when all doors and the trunk are closed.

110

uu

Indicators

u

Driver Information Interface Warning and Information Messages

In

strum

e

nt Pa

nel

Message

Condition

Explanation

• Appears when the engine oil pressure is low.

• Appears while driving - Immediately stop in a safe 

place.

2 If the Low Oil Pressure Symbol Appears P. 646

• Appears if there is a problem with the shutter grille, 

and the radiator coolant temperature is too high.

• Power output will be reduced, so you may not be able 

to accelerate or maintain your current speed. Have your 
vehicle checked by a dealer.

• Appears when the washer fluid is low.

• Refill the washer fluid.

2 Refilling Window Washer Fluid P. 590

• Appears when the scheduled maintenance is due 

soon.

• Consequently, Maintenance Due Now and 

Maintenance Past Due follow.

2 Maintenance Minder Messages on the Driver 

Information Interface P. 573

Canadian models

111

uu

Indicators

u

Driver Information Interface Warning and Information Messages

Continued

In

strum

e

nt Pa

nel

Message

Condition

Explanation

• Appears when there is a problem with the sensor on 

the 12-volt battery.

• Have your vehicle checked by a dealer.

2 Checking the 12-Volt Battery P. 611

• Appears along with the 12-volt battery charging 

system indicator when the 12-volt battery is not 
charging.

• Turn off the climate control system and rear defogger 

to reduce electricity consumption.

2 If the 12-Volt Battery Charging System Indicator 

Comes On P. 646

• Appears when the engine coolant temperature is 

near its upper limit.

• Drive slowly to prevent overheating.

• Appears when the engine coolant temperature gets 

abnormally high.

2 Overheating P. 643