FE03-0030b

10. Install the air intake duct and tighten the clamp.

FE03-0032b

11. Install the Canister solenoid valve bracket.

12. Connect the battery negative cable.

3.3.8.5  Shift  Control  Assembly  Disassemble
and Assemble

Disassemble Procedure:

Warning!

FE03-0033b

1.

Remove the shift control assembly. Refer to 

3.3.8.4

 

Shift

Control Assembly Replacement

.

2.

With a plier, remove the shift control outer retaining ring.

Transmission / Drive Axle

Manual Transmission

3-67

FE03-0034b

3.

Remove the shift control locking pin.

FE03-0035b

4.

Remove the selector shaft sleeve.

FE03-0036b

5.

Remove the selector shaft retaining bolts.

3-68

Manual Transmission

Transmission / Drive Axle

FE03-0037b

6.

Remove  the  selector  shaft  oil  seal  as  shown  in  the
graphic.

FE03-0038b

7.

With a plier, remove the shift control inner retaining ring.

FE03-0039b

8.

Remove the selector shaft oil seal to complete the shift
control assembly disassemble.

Transmission / Drive Axle

Manual Transmission

3-69

Assemble Procedure:

0-0.5mm

FE03-0040b

1.

With a special tool GL201-012, install the selector shaft
oil seal.

Seal Face To Face Seal Hole Distance:
0-0.5 mm (0-19.685 × 10

-3

 in)

2.

Install the selector shaft.

FE03-0041b

3.

Install the selector shaft inner retaining ring.

2.0-2.5mm

FE03-0042b

4.

With a special tool GL201-013, install the selector shaft
oil seal.

Seal Surface To Seal Hole Surface Distance:
2.0-2.5 mm (78.740-98.425 × 10

-3

 in)

3-70

Manual Transmission

Transmission / Drive Axle