|
|
|
128
Seats
Adjusting the Front Seat Manually
To move the front seat forward or rearward:
1.
Find the adjustment lever at the lower left
corner of the front seat.
2.
Push the lever to the left to unlatch the seat.
3.
Move the seat to the desired position.
4.
Release the lever to latch the seat in its new
position. Make sure the seat locks securely in
place.
Adjusting bucket seat
Adjusting the bench seat
129
R
WARNING
Never adjust the driver’s seat or seatback
when the vehicle is moving.
R
WARNING
Do not pile cargo higher than the
seatbacks to avoid injuring people in a
collision or sudden stop.
R
WARNING
To reduce the risk of serious injury in a
collision, always drive and ride with your
seatback upright and the lap belt snug
and low across the hips.
R
WARNING
To reduce the risk of serious injury in a
collision, children should always ride with
the seatback upright.
Reclining Bucket Seats
You can tilt the seat back of your bucket seats
backward.
1.
On the outboard side of the seat, lift the
recliner handle up and hold it in place.
2.
Lean against the back of the seat and adjust
it to the position you want.
3.
Release the handle to lock the seat back in
place.
4.
To return the seat back upright, lift the
handle and lean forward.
130
Reclining bucket seat
Lifting the seat-back adjustment lever of an
unoccupied seat will allow the seat back to fold
forward for access to the rear. Pushing the seat
back backward with the handle released returns
the seat upright.
Seat Back Release (Bench Seat)
The split back bench seat can be folded forward
on either side to gain access to the rear of the
vehicle. To do so, push up the latch button
located at the top of the seat back.
Seat back release
131
R
WARNING
A seatback which is folded forward even
a small degree may not lock properly in
the event of a sudden stop or collision.
Rear Flip Fold Seat
To fold the seat forward:
1.
The seat back latch is at the lower rear right
hand side of the seat. Lift the latch handle to
unlock the seat back.
2.
Fold the seat back over the seat cushion
until it locks into place.
3.
Unlock the seat from the floor striker by
lifting the seat latch handle at the center rear
edge of the seat.
4.
Lift the seat and fold forward.
To remove and reinstall the rear flip-fold
seat:
1.
Remove the torque rod by releasing it from
the right hand floor bracket (by pushing
forward and up).
2.
Remove the pin spring retainers and the pins
from both the floor brackets.
3.
Remove the seat assembly from your Bronco.
Reverse this procedure to install the rear
flip-fold seat.
NOTE:
It is important that you do not damage
the seat belt hardware while removing
or installing the rear flip-fold seat.
|
|
|