|
|
|
124
Opening the remote transmitter
The transmitter can be snapped apart to replace
the batteries by twisting a thin coin between the
two halves of the transmitter. DO NOT TAKE
THE FRONT PART OF THE TRANSMITTER
APART. When installing the new batteries, be
sure to place the positive (+) side down as
marked. Snap the two halves back together.
Replacing the batteries
Replacing lost transmitters
In the event a transmitter is lost, you should
take all your vehicle’s transmitters to your
dealer to have the remote entry system
deprogrammed for the lost transmitter. This is
necessary to prevent further unauthorized use of
the lost transmitter.
125
You can also purchase additional transmitters
(up to 4 transmitters can be used) from your
dealer. You will need to take all your
transmitters to the dealer so they can program
them to the remote entry system all at the same
time.
Illuminated Entry System (If equipped)
This system will provide illumination of the
vehicle’s interior courtesy lamps when either
outside front door handle is pulled or when the
Remote Entry System is used to unlock the door
or sound the Personal Alarm. The system will
automatically turn off after approximately 25
seconds or when the ignition is turned to the
START or ACCESSORY position.
NOTE:
The inside lights will not turn off if
you have turned them on with the
dimmer knob or if any door is open.
Battery Saver (with Remote Entry — If
equipped)
When the ignition is turned off, the vehicle will
turn off battery voltage to all of these lights after
40 minutes: glove box, engine compartment,
overhead console, mirror, courtesy and
interior (including cargo) lamps.
This will prevent draining of the battery if these
lights have been left on inadvertently or if a
door is not completely closed. Battery voltage to
these lamps will be restored when the remote
entry transmitter is used, any door is opened, or
the ignition key is turned on again.
126
Windows
Tailgate Window
The switch to operate the tailgate window is on
the instrument panel to the left of the steering
column next to the master lighting switch. With
the ignition in the ON or ACC position, move
the switch down to lower the window and move
it up to raise the window. You can also operate
the tailgate window by using the key from the
outside of the tailgate.
R
WARNING
When driving your vehicle make sure that
the tailgate door and window are closed
to prevent exhaust fumes from being
drawn into the vehicle. This will also
prevent passengers and cargo from falling
out.
If you must drive with the rear window open:
❑
Adjust your climate control system to force
outside air into your vehicle.
❑
Completely open the outside air vents if your
vehicle is so equipped.
❑
You can prevent the tailgate from accidentally
opening by raising the glass one inch from
the fully opened position.
127
Rear window switch
When driving in extremely dusty areas, clean the
tailgate glass periodically to prevent build-up of
surface dust. This will prevent excessive wear or
damage to the tailgate window seals.
Using the Power Windows (If equipped)
Each door has a power control that opens and
closes the window on that door. The driver’s
door has a master control switch that operates
both front door windows. You must place the
ignition switch in the ON or ACC position to
use your power window controls.
R
WARNING
Do not let children play with the power
windows. They may seriously hurt
themselves. Make sure occupants are clear
of the window(s) before closing.
Master control switch
|
|
|