|
|
Content .. 1513 1514 1515 1516 ..
RESERVOIR REMOVAL 1. Remove power steering pump from vehicle. (Refer to 19 - STEERING/PUMP - REMOVAL) 2. Clean exterior of pump. 3. Clamp pump body in a soft jaw vice. NOTE: Use new retaining clips for installation. 4. Pry up tab and slide each retaining clip (2) off pump (1). Discard clips (2). 5. Remove fluid reservoir (1) from pump housing. Remove and discard O-ring seal. INSTALLATION 1. Lubricate new O-ring Seal with clean ATF+4 fluid or equivalent. 2. Install O-ring seal in housing. 3. Install reservoir (1) onto housing. 4. Slide and tap in NEW reservoir retainer clips (2) making sure each tab locks into place on housing. 5. Install power steering pump on vehicle. (Refer to 19 - STEERING/PUMP - INSTALLATION) 6. Fill power steering pump reservoir to correct fluid level. (Refer to 19 - STEERING/PUMP/FLUID - STANDARD PROCEDURE) 19 - 94 PUMP - SRT-10 DR/DH |