|
|
(M) Check Engine Lamp (MIL) will illuminate during engine operation if this Diagnostic Trouble Code was (G) Generator Lamp Illuminated GENERIC SCAN TOOL CODE DRB SCAN TOOL DISPLAY DESCRIPTION OF DIAGNOSTIC TROUBLE CODE P0420 (M) 1/1 Catalytic Converter Efficiency Catalyst 1/1 efficiency below required level. P0432 (M) 1/2 Catalytic Converter Efficiency Catalyst 2/1 efficiency below required level. P0441 (M) Evap Purge Flow Monitor Insufficient or excessive vapor flow detected during evaporative emission system operation. P0442 (M) Evap Leak Monitor Medium Leak Detected A small leak has been detected in the evaporative system. P0443 (M) Evap Purge Solenoid Circuit An open or shorted condition detected in the EVAP purge solenoid control circuit. P0455 (M) Evap Leak Monitor Large Leak Detected A large leak has been detected in the evaporative system. P0456 Evap Leak Monitor Small Leak Detected A small leak has been detected in the evaporative system. P0460 Fuel Level Unit No Change Over Miles No movement of fuel level sender detected. P0461 Fuel Level Unit No Changeover Time No level of fuel level sender detected. P0462 Fuel Level Sending Unit Volts Too Low Fuel level sensor input below acceptable voltage. P0463 Fuel Level Sending Unit Volts Too High Fuel level sensor input above acceptable voltage. P0500 (M) No Vehicle Speed Sensor Signal No vehicle speed sensor signal detected during road load conditions. P0505 (M) Idle Air Control Motor Circuits Replace P0522 Oil Pressure Sens Low Oil pressure sensor input below acceptable voltage. P0523 Oil Pressure Sens High Oil pressure sensor input above acceptable voltage. P0551 (M) Power Steering Switch Failure Incorrect input state detected for the power steering switch circuit. PL: High pressure seen at high speed. P0600 (M) PCM Failure SPI Communications No communication detected between co-processors in the control module. P0601 (M) Internal Controller Failure Internal control module fault condition (check sum) detected. P0604 Internal Trans Controller Transmission control module RAM self test fault detected. -Aisin transmission. P0605 Internal Trans Controller Transmission control module ROM self test fault detected -Aisin transmission. P0622 (G) Generator Field Not Switching Properly An open or shorted condition detected in the generator field control circuit. P0645 A/C Clutch Relay Circuit An open or shorted condition detected in the A/C clutch relay control circuit. JX EMISSION CONTROL SYSTEMS 25 - 7 DESCRIPTION AND OPERATION (Continued) |