|
|
Section 08 DRIVE SYSTEM Subsection 03 (DRIVEN PULLEY) Install slider shoes as per following photo. Red A30D0WA 1 1 2 2 2 1 1. BLACK slider shoe Screws Screws no. 12 are machined at their end. With CAUTION: If any of these screws is not flush Assemble driven pulley components by reversing Cam Coat cam no. 11 interior with Loctite antiseize lu- INSTALLATION Countershaft Apply Loctite antiseize lubricant (P/N 293 800 070) CAUTION: Always apply antiseize lubricant on Should installation procedure be required, refer to Reinstall the pulley on the countershaft no. 5 by ADJUSTMENT Cam Make sure to install proper cam no. 11. Refer to Cam angle is identified on cam. A30D0XA NOTE: For high altitude regions, a service bulletin Spring To check spring preload adjustment, use the 529 006 500 Remove drive belt. mmr2005-088 347 |