|
|
Section 03 ENGINES Subsection 05 (TOP END) Remove piston from connecting rod. Install locating sleeve. Then push needle bearings 1 A02C2FA 2 TYPICAL INSPECTION NOTE: For dimension measurement procedures, RAVE Valves There are no wear parts anywhere in the system BRP suggests annual cleaning of the valve. If a No special solvents or cleaners are required when Check valve rod housing and cylinder for clogged 1 A32C16A 2 1. Draining hole NOTE: Oil dripping from draining hole indicates a Check for cracked, dried or perforated bellows Check if the compression springs no. 7 are in ENGINE SPRING P/N COLOR WIRE DIA. mm (in) FREE LENGTH mm (in) 593 420 239 944 Brown 0.9 (.035) 48.5 (1.91) 593 HO 420 239 944 Brown 0.9 (.035) 48.5 (1.91) 593 HO SDI 420 239 942 Black 0.8 (.031) 42.5 (1.67) 793 HO (All models except Summit) 420 239 941 Blue 0.8 (.031) 52.5 (2.07) 793 HO (Summit) 420 239 942 Black 0.8 (.031) 42.5 (1.67) Power Tek and SDI Engines Check if solenoid heating element is still functional NOTE: Make sure hoses are not kinked or dam- mmr2005-072 103 |