Snowmobile Polaris 600 IQ LXT (2015 year). Manual - part 9

39

FEATURES

Instrumentation

MFD Digital Display Programs

Press and release the MODE button to cycle through the three MFD 
programs: Performance, Engine and History. Each program remains 
active until you cycle to the next program. While any program is active, 
press and release the SET button to cycle through the program’s screens.

Performance Program

The Performance Program automatically displays either speed or 
tachometer, whichever is opposite the analog display. See page 38. It 
also displays electrical system voltage and fuel level (if equipped).

While in the Performance mode, press the SET button to cycle through 
the odometer, Trip 1, Trip 2, Trip F (if equipped with electronic fuel 
gauge) and Clock (if equipped). Use the following procedures to make 
changes to these screens.

Odometer Setting

The odometer records the vehicle's total 
distance traveled since manufacture. The 
odometer cannot be reset.

40

FEATURES

Instrumentation

MFD Digital Display Programs

Trip Settings

Trip 1 and Trip 2 are odometers used 
to check fuel mileage or to keep 
track of distance traveled. Both 
odometers can be reset to zero. 

1. Enter the Performance Program.

2. Press and release the SET button 

until the desired trip screen is 
active.

3. Press and hold the SET button for two seconds to reset the trip 

odometer to zero.

4. Press and release the SET button to cycle through additional 

screens.

41

FEATURES

Instrumentation

MFD Digital Display Programs

Performance Program
Trip Settings

If the snowmobile is equipped with an 
electronic fuel gauge, Trip F 
automatically displays when the fuel 
level is low. The fuel symbol and the last 
fuel bar on the MFD gauge will blink 
when the fuel level reaches 1/8th tank.

The Trip F odometer records distance 
traveled until enough fuel is added to 
raise the level above 1/4 tank. The fuel 
symbol and the fuel bar will continue to 
blink until the fuel level is above 1/4 
tank. The Trip F odometer will 
automatically reset to zero after refueling.

42

FEATURES

Instrumentation

MFD Digital Display Programs

Performance Program
Clock Setting (if equipped)

1. Enter the Performance Program.

2. Press and release the SET button 

until the clock screen is active.

3. Press and hold the SET button for 

five seconds.

4. When the hour starts flashing, 

press the SET switch once to advance one hour. (Press and hold the 
SET button to advance the hours quickly.)

5. Press and release the MODE button to save the hour. The minutes 

will begin flashing.

6. Set the minutes in the same manner.

7. When finished, press and release the MODE button to save the new 

setting. If the MODE button is not pressed within ten seconds, the 
gauge will automatically save the new entry.