Snowmobile Polaris 600 IQ Touring (2010 year). Manual - part 9

37

FEATURES

Instrumentation

MFD Settings

The MFD control switch allows you 

to set the MFD display to your pref-

erences. The rocker switch has a 

MODE button (top) and a SET but-

ton (bottom). Specific instructions 

are outlined on the following pages.
Standard vs. Metric
The MFD will display either stan-

dard or metric units of measurement. 

While viewing a screen that displays 

measurements (MPH, km/h or tem-

peratures), press and hold the MODE switch until the unit of measure-

ment changes (about 10 seconds). 

MFD Control Switch

SET

MODE

38

FEATURES

Instrumentation

MFD Settings

Speedometer/Tachometer
The speedometer and tachometer can be viewed in either the analog or 

the digital display. If the analog display is set to show speedometer read-

ings, the digital screen will automatically display the tachometer (option 

1). If the analog is set to show the tachometer, the digital screen will 

show the speedometer (option 2).
To change viewing preferences, press and hold the MODE button for 

three seconds. When the button is released, the new setting becomes 

active and screen colors change. See table below.

Option

Analog

Display

Digital

Display

Analog

Screen

Digital

Screen

1

Speed

RPM

Blue “MPH”

Blue

Backlight

2

RPM

Speed

Red 

“X100RPM”

Red

Backlight

39

FEATURES

Instrumentation

MFD Digital Display Programs

Press and release the MODE button to cycle through the three MFD pro-

grams: Performance, Engine and History. Each program remains active 

until you cycle to the next program. While any program is active, press 

and release the SET button to cycle through the program’s screens.
Performance Program

The Performance Program automatically displays either speed or 

tachometer, whichever is opposite the analog display. See page 38. It 

also displays electrical system voltage and fuel level (if equipped).
While in the Performance mode, press the SET button to cycle through 

the odometer, Trip 1, Trip 2, Trip F (if equipped with electronic fuel 

gauge) and Clock (if equipped). Use the following procedures to make 

changes to these screens.
Odometer Setting
The odometer records the vehicle's total 

distance traveled since manufacture. The 

odometer cannot be reset.

40

FEATURES

Instrumentation

MFD Digital Display Programs

Trip Settings
Trip 1 and Trip 2 are odometers used 

to check fuel mileage or to keep 

track of distance traveled. Both 

odometers can be reset to zero. 
1. Enter the Performance Program.
2. Press and release the SET button 

until the desired trip screen is 

active.

3. Press and hold the SET button for two seconds to reset the trip 

odometer to zero.

4. Press and release the SET button to cycle through additional 

screens.