Isuzu D-Max / Isuzu Rodeo (TFR/TFS). Manual - part 262

15

11. To program more illustration press soft key.

Program more Keys!

YES

NO

12. See programming result.

Erase transponder key

1. Select Erase TP-Key mode.

2. See immobilizer status on Tech 2 screen and type security code. If the status does not allow the

programming, only immobilizer status is displayed.

3. See illustration of caution.

CAUTION: All Transponder-Keys Will Be Erased!

Confirm

Erasing Transponder-Keys

CAUTION

Erase

4. See programming result on display.

16

4.  Reset Immobilizer ICU (Immobilizer Control Unit) (Gas Engine Model)

CAUTION:

Do not reset immobilizer ICU for diesel engine models.

1. Select “Body” and “Immobilizer”.

2. Select “Additional Function” and “Reset Immobilizer”.

3. Enter the security code and press Confirm.

4. Reset Immobilizer screen shows up with warning. See the following screen.

Do this only before replace the immobilizer ECU

Confirm

Reset Immobilizer

Warning: Engine will not start after reset!

5. When reset is completed, the following screen shows up.

Program completed

Confirm

17

5.  Programming ICU, ECM

Program immobilizer ICU (Gas Engine Model)

1. Select “Body” and “Immobilizer”.

2. See immobilizer status on the display of Tech 2.

3. Select engine type.

4. Enter the security code.

5. See ECM status.

6. Input a program option by moving the cursor on the selection, then press Enter.

7. Select “Immobilizer installed”.

Immobilizer installed

Engine Control Module installed

Immobilizer And ECM installed

Confirm

Input Program Option

8. Input the security code, then press the soft key of “Okay” or “Not Okay”.

Security Code

0000

Press ENTER Key to continue

Not

Okay

Okay

CAUTION

9. Enter VIN.

Vehicle Identification Number:

00000000000000000

Press ENTER Key to continue

Not

Okay

Okay

Enter VIN Input Screen

18

10. Enter Mechanical key number.

Mechanical Key Number:

- - - - - - -

Press ENTER Key to continue

Not

Okay

Okay

Enter Key No. Input Screen

11. Turn ON ignition.

Ignition Status                                        Off  0V

 

Turn Ignition On!

Turn On Ignition

12. See the programming result.

Tech 2 displays the result of programming as the following.
Follow those instructions.

Selected Programming is not possible due to wrong System Status!
Immobilizer Not Programmed!
Immobilizer Already Programmed!
ECM Not Programmed!
ECM Already Programmed!

13. Transponder key must be reprogrammed, because all transponder information is erased

when ICU is programmed. See Transponder programming.