|
|
Toothed segment Note The toothed segment 9538/1 must be bored to ø 15 mm to guarantee a perfect fit and to avoid damaging the 1. Fasten toothed segment 9538/1 to the crankcase with an M12 x 50 hexagon-head bolt. Note To avoid deforming the clutch pressure plate, loosen and tighten the fastening screws in at least five steps in Stop on adjustment mechanism Note When loosening the clutch pressure plate, ensure that the stop on the adjustment mechanism -arrow- is 2. Detach pressure plate. 3. Remove pressure plate and drive plate. Installing clutch Installing clutch Note Clean the friction surfaces of the flywheel and pressure plate prior to installation, e.g. with brake • Diagnostic system: reading out fault memory and activating systems Removing clutch 861 |