|
|
3. Hold trip meter knob for at least 5 seconds. Odometer should indicate "000000" and MAINT REQD light goes off. If system fails to reset, the MAINT REQD light will continue to flash. Repeat reset procedure. ENGINE OIL CHANGE REMINDER LIGHT RESET - PROCEDURE 7 1. Turn ignition key to LOCK position with odometer reading showing. 2. Turn ignition key to ON position while holding down on trip meter reset knob. A message MAINT REQD RESET MODE will appear on display. 3. Hold trip meter knob for at least 5 seconds. A message COMPLETE will appear and beep will be heard. If system fails to reset, repeat reset procedure. ENGINE OIL CHANGE REMINDER LIGHT RESET - PROCEDURE 8 1. OIL REPLACEMENT INFORMATION MODE RESET OPERATION HINT: The TRIP meter reset knob is located below the speedometer. This reset operation is required only for U.S.A.. a. Turn the ignition switch on (IG). b. Press the ODO/TRIP switch until the ODO meter appears. c. Turn the ignition switch off. d. Turn the ignition switch on (IG) while pressing and holding the TRIP meter reset knob. Hold the TRIP meter reset knob until the following conditions are met and 5 seconds have passed. The multi-information display shows "Resetting Oil Maintenance Data". When oil replacement reminder light turns off, the reset is complete.
2009 Toyota Tundra GENERAL INFORMATION Service Reminder Indicators - Toyota
|