EN(H6DO)-298
ENGINE (DIAGNOSTICS)
DIAGNOSTIC PROCEDURE WITH DIAGNOSTIC TROUBLE CODE (DTC)
7
CHECK INHIBITOR SWITCH GROUND LINE.
Measure resistance of harness between inhibi-
tor switch connector and engine ground.
Connector & terminal
(T7) No. 12 — Engine ground:
Is the measured value less than the specified
value?
5
Ω
Go to step 8.
Repair open circuit
in harness
between inhibitor
switch connector
and starter motor
ground line.
NOTE:
In this case, repair
the following:
• Open circuit in
harness between
inhibitor switch
connector and
starter motor
ground line
• Poor contact in
starter motor con-
nector
• Poor contact in
starter motor
ground
• Starter motor
8
CHECK INHIBITOR SWITCH.
By moving select lever to “N” and “P” positions,
measure resistance between inhibitor switch
connector socket terminal.
Terminals
No. 7 — No. 12:
Is the measured value less than the specified
value?
1
Ω
Go to step 9.
Replace inhibitor
switch. <Ref. to
AT-49, Inhibitor
Switch.>
9
CHECK SELECTOR CABLE CONNECTION.
Is there any fault in selector cable connection
to inhibitor switch?
There is a malfunction.
Repair selector
cable connection.
<Ref. to CS-12,
Select Cable.>
Contact SUBARU
distributor service.
NOTE:
Inspection by DTM
is required, be-
cause probable
cause is deteriora-
tion of multiple
parts.
Step
Value
Yes
No