SsangYong Musso. Manual - part 103

GENERAL INFORMATION  0B-13

SSANGYONG  Y158

Usage

Engine Oil

 (Change with filter)

Engine Coolant

Automatic Transaxle Fluid

Mannal Transaxle Fluid

Transfer Case

Brake / Clutch Fluid

Power Steering System

Parking Brake Cable

Hood Latch Assembly

Hood and Door Hinges

Fuel Door Hinge

Rear Compartment Lid Hinges

Weatherstrips

RECOMMENDED FLUIDS AND LUBRICANTS

Capacity

8.2 L

7.5 L

11.3 L

10.5 L

9 L

3.4 L

1.2 L

1.4 L

Approx. 0.5L level must

be maintained between

MAX & MIN level

1.0 L

As required

As required

As required

As required

Fluid/Lubricant

Quality class - API ; SH grade or above

ACEA ; A2 or A3

MB sheet ; 229.1

Viscosity       - MB sheet ; 224.1

ALUTEC P-78

CASTROL TQ95

ATF DEXTRON II, III

ATF S-2, S-3, S-4, TOTAL FIUID ATX

ATF DEXTRON II, III

ATF S-2, S-3, S-4, TOTAL FIUID ATX

DOT-3 & SAE J 1703

ATF DEXRON-II

Grease

Grease

Spray type grease

Silicone grease

3.2L DOHC

2.3L DOHC

3.2L DOHC

2.3L DOHC

Part Time

Full Time

0B-14  GENERAL INFORMATION

SSANGYONG  Y158

GENERAL REPAIR INSTRUCTIONS

If a floor jack is used, the following precautions are
recommended.

•••••

Park the vehicle on level ground, “block” the front or
rear wheels, set the jack against the frame, raise
the vehicle and support it with chassis stands and
then perform the service operation.

•••••

Before performing the service operation, disconnect
the negative battery cable in order to reduce the
chance of cable damaged and burning due to short-
cir cuiting.

•••••

Use a cover on the body, the seats and the floor to
protect them against damage and contamination.

•••••

Handle brake fluid and antifreeze solution with care
as they can cause paint damage.

•••••

The use of proper tools, and the recommended
essential and available tools where specified, are
important for efficient and reliable performance of the
service repairs.

•••••

Use genuine SSANGYONG parts.

•••••

Discard used cotter pins, gaskets, O-rings, oil seals,
lock washers and self-locking nuts. Prepare new
ones for installation. Normal function of these parts
cannot be maintained if these parts are reused.

•••••

Keep the disassembled parts neatly in groups to
facilitate proper and smooth reassembly.

•••••

Keep attaching bolts and nuts separated, as they
vary in hardness and design depending on the
position of the installation.

•••••

Clean the parts before inspection or reassembly.

•••••

Also clean the oil parts, etc. Use compressed air to
make certain they are free of restrictions.

•••••

Lubricate rotating and sliding faces of parts with oil
or grease before installation.

•••••

When necessary, use a sealer on gaskets to prevent
leakage.

•••••

Carefully observe all specifications for bolt and nut
torques.

When service operation is completed, make a final check
to be sure service was done properly and the problem
was corrected.

GENERAL DESCRIPTION AND SYSTEM OPERATION

GENERAL INFORMATION  0B-15

SSANGYONG  Y158

VEHICLE IDENTIFICATION NUMBER SYSTEM

* K P T L 4 B 1 9 S 1 P 000000 *

12~17. Production Serial Number

: 000001- 999999

11. Plant Code

P : PyongTaek Plant

10. Model Year

1 : 2001

2 : 2002

3 : 2003

4 : 2004

5 : 2005

9. Check Digit

S : All area except North America

8. Engine Type

6 : 2295cc, In-line 4Cylinder, Gasoline (E23)

9 : 3199cc, In-line 6Cylinder, Gasoline (E32)

D : 2874cc, In-line 5Cylinder, Diesel  (662LA)

7. Restraint System

1 : 3-Point Safety Belt, 2 : 2-Point Safety Belt

6. Trim Level

A : Standard, B : Deluxe, C : Super Deluxe

5. Body Type

0 : 5-Door

1 : 4-Door

2 : 3-Door

4 : 3-Door Soft Top

4. Line Models

E : Musso, LHD

F : Musso, RHD

L : Korando, LHD

R : Korando, RHD

3. Vehicle Type

T : Passenger Car,  A : Truck

2. Maker ldentification : P

1. Nation : K

*. Symbol according to No.

KAC0B010

0B-16  GENERAL INFORMATION

SSANGYONG  Y158

Manufacturer’ s Plate

1 Type Approval No.

2 Vehicle Identification No.

Manufacturer’ s Plate Location

Gasoline Engine

Engine Number Location

Gasoline Engine Number

Serial Number

0 : Manual T/M
1 : Hydr - Auto Coupling
2 : Automatic T/M

99 : 3.2L
97 : 2.3L

0 : Common
1 : Left - Hand Drive
2 : Right - Hand Drive

ENGINE TYPE

0 : MUSSO
3 : KORANDO

3.2L DOHC Gasoline Engine

The engine number is stamped on the lower rear side of
the alternator.

  162 993 1 0 012345

KAC0B030

YAA0B030

KAC0B020

YAA0B100