Scania 16 litre engine. Work Description - part 30

0120w13b.mkr

©

117

Removing

1

Drain the engine oil from the oil sump. 
Clean the magnetic plug and torque tighten 
to 80 Nm.

2

Remove the oil sump.

3

Remove the gearbox (refer to group 5). 
Support the engine using tool 99 318. 
Remove the clutch.

4

Remove the flywheel as described in 
Flywheel, removing.

5

Remove the rear exhaust manifold.

6

Remove the flywheel housing as described 
in Flywheel housing, removing.

7

Remove the strainer and the suction pipe.

8

Remove the oil pump.

Oil pump

118

©

0120w13b.mkr

Fitting

1

Renew the O-ring and fit a new oil pump.

2

Renew the O-rings and refit the strainer and 
suction pipe.

3

Fit the flywheel housing as described in 
Flywheel housing, fitting.

4

Refit the air compressor and exhaust 
manifold. Torque tighten the exhaust 
manifold to 63 Nm.

5

Fit the flywheel as described in Flywheel, 
fitting.

6

Refit the clutch and gearbox.

7

Fit the oil sump and torque tighten the bolts 
to 32 Nm.

8

Fill with oil and check the oil level in the 
engine using the dipstick.

Oil pump

0125w13b.mkr

©

119

Exhaust manifold

Renewing gaskets

Tightening torque

1

Undo the bolts and remove the front exhaust 
manifold.

2

Undo the bolts and remove the rear exhaust 
manifold.

3

Scrape away the gaskets from the exhaust 
manifolds and cylinder head.

4

Lubricate the joints with heat-resistant 
grease and fit new gaskets.

5

Fit the rear exhaust manifold and junction 
pipe.

6

Fit the front exhaust manifold.

7

Torque tighten all bolts to 63 Nm.

Bolts for exhaust manifold

63 Nm

Exhaust manifold

©