|
|
P0606 ECM EC-361 < DTC/CIRCUIT DIAGNOSIS > [VK56DE] C D E F G H I J K L M A EC N P O P0606 ECM DTC Logic INFOID:0000000010118762 DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1. PRECONDITIONING 1. Turn ignition switch OFF and wait at least 10 seconds. 2. Turn ignition switch ON. 3. Turn ignition switch OFF and wait at least 10 seconds. TESTING CONDITION: Before performing the following procedure, confirm that battery voltage is 11 V or more with ignition switch ON. >> GO TO 2. 2. PERFORM DTC CONFIRMATION PROCEDURE-I 1. Turn ignition switch ON (engine stopped) and wait at least 10 seconds. CAUTION: Never start engine during this procedure. 2. Turn ignition switch OFF and wait at least 10 seconds. 3. Turn ignition switch ON. 4. Check 1st trip DTC. YES >> Proceed to . NO >> GO TO 3. 3. PERFORM DTC CONFIRMATION PROCEDURE-II 1. Start engine. 2. Rev up the engine quickly to approximately 3,000 rpm under unloaded condition and completely release the accelerator pedal. 3. Let the engine idle and wait at least 10 seconds. 4. Turn ignition switch OFF and wait at least 10 seconds. 5. Turn ignition switch ON. 6. Check 1st trip DTC. YES >> Proceed to . NO >> INSPECTION END Diagnosis Procedure INFOID:0000000010118763 1. PERFORM DTC CONFIRMATION PROCEDURE 1. Turn ignition switch ON. 2. Erase DTC. 3. Perform DTC confirmation procedure for 3 times. Refer to . Is the 1st trip DTC P0606 displayed again? YES >> Replace ECM. NO >> INSPECTION END DTC No. CONSULT screen terms (Trouble diagnosis content) DTC detecting condition Possible cause P0606 CONTROL MODULE Malfunction in ECM processor. ECM |