|
|
SEC-16 < SYSTEM DESCRIPTION > SYSTEM NOTE: the detection area of outside key antenna. For details, refer to SEC-10, "INTELLIGENT KEY SYSTEM/ENGINE START FUNCTION : DISARMED Phase The vehicle security system is not set in the DISARMED phase. The vehicle security system stays in this phase while any door is open because it is assumed that the owner is inside or nearby the vehicle. Security indicator lamp blinks every 2.4 seconds. When the vehicle security system is reset, each phase switches to the DISARMED phase directly. PRE-ARMED Phase The PRE-ARMED phase is the transient state between the DISARMED phase and the ARMED phase. This phase is maintained for 30 seconds so that the owner can reset the setting due to a mis-operation. This phase switches to the ARMED phase when vehicle conditions are not changed for 30 seconds. Security indicator lamp illuminates while being in this phase. To reset the PRE-ARMED phase, refer to the switching condition of No. 10 in the table above. ARMED Phase The vehicle security system is set and BCM monitors all necessary inputs. If any door is opened without using Intelligent Key, vehicle security system switches to the ALARM phase. Security indicator lamp blinks every 2.4 seconds. To reset the ARMED phase, refer to the switching condition of No. 11 in the table above. ALARM Phase BCM transmits “Theft Warning Horn Request” signal and “High Beam Request” signal intermittently to IPDM E/R via CAN communication. In this phase, horns and headlamps are activated intermittently for approxi- mately 50 seconds to warn that the vehicle is accessed by unauthorized means. ON/OFF timing of horns and headlamps are synchronized. After 50 seconds, the vehicle security system returns to the ARMED phase. At 3 ARMED to When one condition of A and A B Intelligent Key: Not used • Any door: Open 4 DISARMED to No conditions 5 PRE-ARMED 6 ARMED to 7 ALARM to 8 PRE-RESET to 9 PRE-RESET to 10 PRE-ARMED When one of the following • Power supply position: ACC/ON/CRANKING/RUN 11 ARMED to When one of the following • Power supply position: ACC/ON/CRANKING/RUN 12 ALARM to 13 RE-ALARM When one of the following • Any door: Open No. System state Switching condition |