|
|
PCS B26F1 IGNITION RELAY PCS-63 < DTC/CIRCUIT DIAGNOSIS > [POWER DISTRIBUTION SYSTEM] C D E F G H I J K L B A O P N B26F1 IGNITION RELAY DTC Logic INFOID:0000000009567612 DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1. PERFORM DTC CONFIRMATION PROCEDURE 1. Turn ignition switch ON, and wait for 2 seconds or more. 2. Perform Self-diagnosis result of BCM with CONSULT. YES >> Go to NO >> Inspection End. Diagnosis Procedure INFOID:0000000009567613 Regarding Wiring Diagram information, refer to . 1. CHECK IPDM E/R SELF-DIAGNOSTIC RESULT 1. Turn ignition switch ON. 2. Erase the DTC of IPDM E/R. 3. Turn ignition switch OFF. 4. Turn ignition switch ON and check the DTC again. YES >> Repair or replace the malfunctioning part. Refer to NO >> GO TO 2. 2. CHECK IGNITION RELAY-1 CONTROL SIGNAL (IPDM E/R) 1. Turn ignition switch ON. 2. Check voltage between BCM connector M98 and ground. Is the inspection result normal? YES >> GO TO 3. NO >> Replace BCM. Refer to BCS-67, "Removal and Installation" 3. CHECK IGNITION RELAY-1 CONTROL SIGNAL CIRCUIT (IPDM E/R) 1. Turn ignition switch OFF. 2. Disconnect BCM connector M98 and IPDM E/R connector E47. 3. Check continuity between BCM connector M98 and IPDM E/R connector E47. Is the inspection result normal? CONSULT Display DTC detecting condition Possible cause IGN RELAY OFF BCM transmits the ignition relay-1 control signal, • Harness or connectors BCM Ground Voltage (Approx.) Connector Terminal M98 98 — 0 V BCM IPDM E/R Continuity Connector Terminal Connector Terminal M98 98 E47 90 Yes |