|
|
TM-62 < COMPONENT DIAGNOSIS > DTC P0732 A/T 2ND GEAR FUNCTION If “TESTING” does not appear on CONSULT-III for a long time, select “SELF-DIAG RESULTS”. In TM-35, "CONSULT-III Function (TRANS- If “COMPLETED RESULT NG” is detected, go to If “STOP VEHICLE” is detected, go to the following step. 6. Stop vehicle. 7. Drive vehicle in “D” position allowing it to shift from 1st to 5th gear and check shift timing and shift shock. - Touch “OK” to complete the inspection when normally shifted from the 1st to 5th gear. - Touch “NG” when an unusual shift shock, etc. occurs in spite of shifting from the 1st to 5th gear. Go to 190, "Check Before Engine Is Started" . - Perform TM-35, "CONSULT-III Function (TRANSMISSION)" when not shifted from the 1st to 5th gear. (Neither “OK” nor “NG” are indicated.) Diagnosis Procedure INFOID:0000000001724389 1. CHECK CAN COMMUNICATION LINE Perform self-diagnosis. Refer to TM-35, "CONSULT-III Function (TRANSMISSION)" , Is a malfunction in the CAN communication indicated in the results? YES >> Check CAN communication line. Refer to NO >> GO TO 2. 2. CHECK TCM POWER SUPPLY AND GROUND CIRCUIT Check TCM power supply and ground circuit. Refer to OK or NG OK >> GO TO 3. NG >> Repair or replace damaged parts. 3. DETECT MALFUNCTION ITEM Check A/T assembly harness connector pin terminals for damage or loose connection with harness connector. OK or NG OK >> GO TO 4. NG >> Repair or replace damaged parts. 4. REPLACE CONTROL VALVE WITH TCM 1. Replace control valve with TCM. Refer to TM-199, "Control Valve with TCM and A/T Fluid Temperature . 2. TM-61, "DTC Confirmation Procedure" OK or NG OK >> INSPECTION END NG >> Confirm malfunction phenomena by “ROAD TEST” to repair malfunctioning part. Refer to "Check Before Engine Is Started" . |