|
|
LAN MAIN LINE BETWEEN DLC AND CGW CIRCUIT LAN-273 < DTC/CIRCUIT DIAGNOSIS > [CAN SYSTEM (TYPE 9)] C D E F G H I J K L B A O P N MAIN LINE BETWEEN DLC AND CGW CIRCUIT Diagnosis Procedure INFOID:0000000009175158 1. CHECK HARNESS CONTINUITY (OPEN CIRCUIT) 1. Turn the ignition switch OFF. 2. Disconnect the battery cable from the negative terminal. 3. Disconnect the following harness connectors. - ECM - CAN gateway 4. Check the continuity between the data link connector and the CAN gateway harness connector. Is the inspection result normal? YES (Present error)>>Check CAN system type decision again. YES (Past error)>>Error was detected in the main line between the data link connector and the CAN gate- way. NO >> Repair the main line between the data link connector and the CAN gateway. Data link connector CAN gateway harness connector Continuity Connector No. Terminal No. Connector No. Terminal No. M22 6 M5 1 Existed 14 7 Existed |