|
|
LAN MAIN LINE BETWEEN IPDM-E AND ABS CIRCUIT LAN-269 < DTC/CIRCUIT DIAGNOSIS > [CAN SYSTEM (TYPE 9)] C D E F G H I J K L B A O P N DTC/CIRCUIT DIAGNOSIS MAIN LINE BETWEEN IPDM-E AND ABS CIRCUIT Diagnosis Procedure INFOID:0000000009175154 1. CHECK HARNESS CONTINUITY (OPEN CIRCUIT) 1. Turn the ignition switch OFF. 2. Disconnect the battery cable from the negative terminal. 3. Disconnect the following harness connectors. - ECM - IPDM E/R - ABS actuator and electric unit (control unit) 4. Check the continuity between the IPDM E/R harness connector and the ABS actuator and electric unit (control unit) harness connector. Is the inspection result normal? YES (Present error)>>Check CAN system type decision again. YES (Past error)>>Error was detected in the main line between the IPDM E/R and the ABS actuator and electric unit (control unit). NO >> Repair the main line between the IPDM E/R and the ABS actuator and electric unit (control unit). IPDM E/R harness connector ABS actuator and electric unit (control unit) harness connector Continuity Connector No. Terminal No. Connector No. Terminal No. E119 29 E125 25 Existed 28 15 Existed |