|
|
POWER SUPPLY AND GROUND CIRCUIT HAC-117 < DTC/CIRCUIT DIAGNOSIS > [AUTOMATIC AIR CONDITIONING] C D E F G H J K L M A B HAC N O P Is the inspection result normal? YES >> GO TO 2. NO >> GO TO 4. 2. CHECK MODE DOOR MOTOR (REAR) GROUND CIRCUIT 1. Turn ignition switch OFF. 2. Disconnect mode door motor (rear) connector. 3. Check continuity between mode door motor (rear) harness connector and ground. Is the inspection result normal? YES >> GO TO 3. NO >> Repair harness or connector. 3. CHECK INSTALLATION OF MODE DOOR MOTOR (REAR) Check mode door motor (rear) is properly installed. Refer to Is the inspection result normal? YES >> Replace mode door motor (rear). Refer to HAC-164, "MODE DOOR MOTOR : Removal and Installation - Mode Door Motor (Rear)" NO >> Repair or replace malfunctioning part. 4. CHECK MODE DOOR MOTOR (REAR) POWER SUPPLY CIRCUIT 1. Turn ignition switch OFF. 2. Disconnect mode door motor (rear) connector and A/C auto amp. connector. 3. Check continuity between mode door motor (rear) harness connector and A/C auto amp. harness connec- tor. Is the inspection result normal? YES >> Replace A/C auto amp. Refer to HAC-157, "Removal and Installation" . NO >> Repair harness or connector. INTAKE DOOR MOTOR INFOID:0000000009176857 Regarding Wiring Diagram information, refer to 1. CHECK INTAKE MODE DOOR MOTOR POWER SUPPLY 1. Turn ignition switch ON. 2. Check voltage between intake mode door motor harness connector and ground. + − Voltage (Approx.) Mode door motor (rear) Connector Terminal M13 1 Ground Battery voltage Mode door motor (rear) — Continuity Connector Terminal M13 3 Ground Yes Mode door motor (rear) A/C auto amp. Continuity Connector Terminal Connector Terminal M13 1 M50 17 Yes |