|
|
ADP-152 < DTC/CIRCUIT DIAGNOSIS > DOOR MIRROR MOTOR DOOR MIRROR MOTOR Description INFOID:0000000009176662 It makes mirror face operate from side to side and up and down with the electric power that automatic drive positioner control unit supplies. Component Function Check INFOID:0000000009176663 1. CHECK DOOR MIRROR MOTOR FUNCTION Check the operation with “MIRROR MOTOR RH” and “MIRROR MOTOR LH” in “ACTIVE TEST” mode with CONSULT. ADP-26, "CONSULT Function (AUTO DRIVE POS.)" . Is the inspection result normal? YES >> Door mirror motor function is OK. NO >> Refer to ADP-152, "Diagnosis Procedure" Diagnosis Procedure INFOID:0000000009176664 Regarding Wiring Diagram information, refer to ADP-55, "WITH AROUND VIEW MONITOR : Wiring Diagram" or ADP-40, "WITHOUT AROUND VIEW MONITOR : Wiring Diagram" . WITH AROUND VIEW MONITOR SYSTEM 1. CHECK DOOR MIRROR MOTOR INPUT SIGNAL 1. Turn ignition switch ON. 2. Check voltage between door mirror connector and ground. Is the inspection result normal? YES >> Refer to ADP-156, "Component Inspection" . NO >> GO TO 2. 2. CHECK HARNESS CONTINUITY 1. Turn ignition switch OFF. 2. Disconnect automatic drive positioner control unit and door mirror. 3. Check continuity between automatic drive positioner control unit connector and door mirror connector. Door mirror LH (+) (–) Door mirror re- mote control switch condition Voltage (V) (Approx.) Door mirror Connector Terminal D28 (LH) D128 (RH) 12 Ground UP Battery voltage Other than above 0 11 LEFT Battery voltage Other than above 0 10 DOWN / RIGHT Battery voltage Other than above 0 Automatic drive positioner control unit Door mirror LH connector Continuity Connector Terminal Connector Terminal M33 12 D28 10 Yes 23 12 24 11 |