|
|
C1101, C1102, C1103, C1104 WHEEL SENSOR BRC-37 < DTC/CIRCUIT DIAGNOSIS > [WITH VDC] C D E G H I J K L M A B BRC N O P Measurement connector and terminal for power supply circuit Measurement connector and terminal for signal circuit Is the inspection result normal? YES >> GO TO 9. NO >> Repair or replace error-detected parts and GO TO 8. 8. PERFORM SELF-DIAGNOSIS (3) 1. Connect ABS actuator and electric unit (control unit) harness connector. 2. Connect wheel sensor harness connector. 3. Erase self-diagnosis result for “ABS”. 4. Turn the ignition switch OFF, and wait 10 seconds or more. 5. Start the engine. 6. Drive the vehicle at approx. 30 km/h (19 MPH) or more for approx. 1 minute. 7. Stop the vehicle. 8. Perform self-diagnosis for “ABS” with CONSULT. Is DTC “C1101”, “C1102”, “C1103” or “C1104” detected? YES >> GO TO 9. NO >> INSPECTION END 9. REPLACE WHEEL SENSOR (2) 1. Replace wheel sensor. - Front: Refer to BRC-98, "FRONT WHEEL SENSOR : Exploded View" - Rear: Refer to BRC-99, "REAR WHEEL SENSOR : Exploded View" 2. Erase self-diagnosis result for “ABS” with CONSULT. 3. Turn the ignition switch OFF, and wait 10 seconds or more. 4. Start the engine. 5. Drive the vehicle at approx. 30 km/h (19 MPH) or more for approx. 1 minute. 6. Stop the vehicle. 7. Perform self-diagnosis for “ABS” with CONSULT. Is DTC “C1101”, “C1102”, “C1103” or “C1104” detected? YES >> Replace ABS actuator and electric unit (control unit). Refer to NO >> INSPECTION END ABS actuator and electric unit (control unit) Wheel sensor Continuity Connector Terminal Connector Terminal E36 9 E22 (Front LH wheel) 1 Existed 5 E39 (Front RH wheel) 3 3 C5 (Rear LH wheel) 5 11 C6 (Rear RH wheel) 7 ABS actuator and electric unit (control unit) Wheel sensor Continuity Connector Terminal Connector Terminal E36 8 E22 (Front LH wheel) 2 Existed 6 E39 (Front RH wheel) 4 2 C5 (Rear LH wheel) 6 12 C6 (Rear RH wheel) 8 Revision: 2013 February 2012 Murano CrossCabriolet |