|
|
WT-32 < DTC/CIRCUIT DIAGNOSIS > TIRE PRESSURE RECEIVER TIRE PRESSURE RECEIVER Component Function Check INFOID:0000000006941831 1. TIRE PRESSURE MONITORING SYSTEM OPERATION With CONSULT 1. Drive for 3 minutes at a speed of 40 km/h (25 MPH) or more, then drive normally for 10 minutes. 2. On “DATA MONITOR”, select “AIR PRESS FL”, “AIR PRESS FR”, “AIR PRESS RR” and “AIR PRESS CAUTION: Stop the vehicle and within 5 minutes, use CONSULT “DATA MONITOR” to display the tire pressure for Is the inspection result normal? YES >> INSPECTION END NO >> Perform trouble diagnosis. Refer to Diagnosis Procedure INFOID:0000000006941832 1. CHECK TIRE PRESSURE RECEIVER SIGNAL 1. Turn the ignition switch ON. CAUTION: Never start the engine. 2. Check tire pressure receiver connector and ground signal with oscilloscope. Is the inspection result normal? YES >> INSPECTION END NO >> GO TO 2. 2. CHECK TIRE PRESSURE RECEIVER INPUT VOLTAGE 1. Turn the ignition switch OFF. 2. Disconnect tire pressure receiver connector. 3. Turn the ignition switch ON. Monitor item Condition Displayed value AIR PRESS FL Drive for 3 minutes at a speed of 40 km/h (25 MPH) or Internal pressure of tires AIR PRESS FR AIR PRESS RR AIR PRESS RL Tire pressure receiver — Condition Voltage (Approx.) Connector Terminal M21 2 Ground Stand by state When receiving the signal from the tire OCC3881D OCC3880D Revision: 2012 March 2011 Murano CrossCabriolet |