Range Rover 2. Electrical Manual - part 208

POWER WINDOWS

L1

6

CIRCUIT DIAGRAM

REV: 11/99

BO

8

C1285

Z238
Body Electrical
Control Module
(BECM)

30

F 2

30 A

3

C1370

C1385R

3

C1386R

C1369

BK

17

5

RN

11

2

S

10

1

C1387R

C1371

YR

8

1

3

C0304R

1

5

M124
Right Rear
Window Motor

M

4

2

YB

BG

5

6

6

C0304R

B

Z238
Body Electrical
Control Module
(BECM)

15

C1285

E0807

3

C1371

C1387R

See Ground
Distribution

5

SO

C1385R

C1370

2

C1369

C1386R

0

[1]

[2]

C1284

C1385L

C1370

2

C0732R

4

1

X189
Right Rear
Window Door
Switch

[1]

Up

[2]

Down

3

C0732R

B

S701R

See Ground
Distribution

S307

B

C1585

(MY 1999)

(MY 2000)

C1586 (MY 2000)

(MY 1999)

C1585

(MY 2000)

(MY 1999)

POWER WINDOWS

L1

7

CIRCUIT DIAGRAM

BO

8

C1285

Z238
Body Electrical
Control Module
(BECM)

30

F 2

30 A

3

C1370

C1385R

3

C1386R

C1369

BK

17

5

RN

11

2

S

10

1

C1387R

C1371

YR

8

1

3

C0304R

1

5

M124
Right Rear
Window Motor

M

4

2

YB

BG

5

6

6

C0304R

B

Z238
Body Electrical
Control Module
(BECM)

15

C1285

E0807

3

C1371

C1387R

See Ground
Distribution

5

SO

C1385R

C1370

2

C1369

C1386R

0

[1]

[2]

C1284

C1385L

C1370

2

C0732R

4

1

X189
Right Rear
Window Door
Switch

[1]

Up

[2]

Down

3

C0732R

B

S701R

See Ground
Distribution

S307

B

SUNROOF

L4

CIRCUIT OPERATION

1

CIRCUIT OPERATION

The sunroof can operate in either slide or tilt mode.
To change from one mode to the other, the sunroof
must be in the closed position, the switch released
and then repressed.

The sunroof functions will be active if the ignition is
selected or for the first 45 seconds after it has been
switched off provided that no door lock signal is
received, in which case the timer will be cancelled.

The sunroof slide function will operate in one of two
modes: one touch, or dead man’s handle. One touch
mode is initiated when the sunroof switch is operated
for less than 400ms, dead man’s handle mode is
initiated when the sunroof switch is operated for
400ms or more. Further operation of either sunroof
switch during the one shot mode will cause the
sunroof to stop operation.

The sunroof tilt function will operate in deadman’s
handle mode only.

There will be trap detection on sunroof close and on
tilt close, but not on opening operations.

If a trap is detected whilst the sunroof is closing from
the slide position, then the sunroof will back off 20cm
or until the motor stalls. If a trap is detected whilst
the sunroof is closing from the tilt position then the
sunroof will back off to the fully tilt open position.
These conditions will also activate a message on the
instrument pack which will be accompanied by three
audible beeps.

With the sunroof in the closed or partially tilted open
position, operation of the sunroof forward switch will
cause the roof to operate in the tilt open direction.
This will continue until the switch is released, or until
a stall condition is detected.

If the sunroof back switch is operated while the
sunroof is in the tilt open position, the roof will
operate in the tilt close direction. This will continue
until the switch is released, a trap is detected or until
the sunroof is in the closed position.

If the sunroof back switch is operated with the
sunroof in the closed or partially open position, the
sunroof will operate in the open direction. This
movement will continue until the switch is released
(unless in the one touch mode), the sunroof forward
switch is operated, or a stall condition is detected.

With the sunroof in an open position, operation of the
sunroof forward switch will cause the sunroof to
operate in the close direction. This will continue until
the switch is released (unless in the one touch
mode), the sunroof back switch is operated, a trap is

detected, or until the sunroof is in the fully closed
position.

The heated rear window will be inhibited for the
duration of any sunroof operation.

Market Deviations:

USA/Canada:

the system will only be active when 
the auxiliary or ignition feeds are on, 
or for the time between switching the
ignition feed off and opening either of
the front doors.

Australia:

the system will only be active 
when the ignition switch is in the 
auxiliary, the ignition or the crank 
position, or for 45 seconds after 
the key is removed from the 
ignition switch.