|
|
Attach the liftgate wiring harness. 3. Connect the liftgate wiring harness electrical connectors. 4. W ith the liftgate closed, check the alignment of the liftgate to the 5. Loosen, but do not remove the liftgate hinge bolts. 6. Position the liftgate central to the aperture. 7. Tighten the liftgate hinge bolts. Torque: 24 Nm 8. Attach the rear of the headliner. 9. Install the LH D-pillar upper trim panel. Refer to: D-Pillar Trim Panel (501-05 Interior Trim and Ornamentation, Removal and Installation). 10. Check for correct operation of the liftgate, and if necessary adjust 11. |