|
|
SCREENS REPAIRS 76-4-3 10. From outside of vehicle, use a Kent knife and carefully cut through sealant securing sides of 11. Using suitable cutting wire, with assistance if required, carefully cut through sealant securing CAUTION: Hold the cutting wire as close to 12. Cut through sealant securing lower edge of screen to body with glazing knife. 13. Attach suction cups and use assistance to remove glass from body. CAUTION: Lay glass on felt covered 14. Collect screen support block. Refit 1. Carefully remove sealant from body to leave a smooth surface. 2. Use a vacuum cleaner to clear away any waste. obtain a smooth surface without damaging 4. Fit screen support block to body. marks as an alignment aid. 7. With assistance, remove screen and place aside. 8. Clean body and sealant face on screen with solvent. CAUTION: Do not touch cleaned or primed 9. Apply etch primer to any bare metal on frame. 10. Apply screen primer to sealant face on screen and allow to cure. 11. Apply primer over etch primer on body. lid, shake out crystals and fit cartridge to |