|
|
ASSEMBLY (1) Soak clutch discs in transmission fluid while assembling other clutch parts. (2) Install new seal rings on clutch retainer hub and input shaft if necessary (Fig. 182). (a) Be sure clutch hub seal ring is fully seated in groove and is not twisted. retainer with transmission fluid. Then press input (4) Install input shaft snap-ring (Fig. 181). site direction until snap-ring is seated. (6) Install new seals on clutch piston. Be sure lip of each seal faces interior of clutch retainer. (7) Lubricate lip of piston seals with generous quantity of Mopar t Door Ease. Then lubricate retainer hub and bore with light coat of transmission (8) Install clutch piston in retainer. Use twisting motion to seat piston in bottom of retainer. A thin CAUTION: Never push the clutch piston straight in. (9) Install piston spring in retainer and on top of piston (Fig. 185). Concave side of spring faces down- (10) Install wave spring in retainer (Fig. 185). Be sure spring is completely seated in retainer groove. Fig. 181 Removing/Installing Input Shaft Snap-Ring 1 – REAR CLUTCH RETAINER Fig. 182 Rear Clutch Retainer And Input Shaft Seal Ring Installation 1 – REAR CLUTCH RETAINER HUB SEAL RING Fig. 183 Input Shaft Seal Ring Identification 1 – BE SURE RING ENDS ARE HOOKED TOGETHER AFTER INSTALLATION 2 – METAL REAR SEAL RING SLIGHTLY BEFORE INSTALLATION FOR BETTER FIT) 21 - 90 TRANSMISSION AND TRANSFER CASE WJ DISASSEMBLY AND ASSEMBLY (Continued) 2000 JEEP GRAND CHEROKEE |