|
|
trical resistance will change. Refer to Instrument FUEL INJECTOR TEST To perform a complete test of the fuel injectors and their circuitry, use the DRB scan tool and refer to the Disconnect the fuel injector wire harness connector from the injector. The injector is equipped with 2 61.2 ohms at 20°C (68°F). SERVICE PROCEDURES FUEL SYSTEM PRESSURE RELEASE Use following procedure if the fuel injector rail is, or is not equipped with a fuel pressure (1) Remove fuel fill cap. tion Center (PDC). For location of relay, refer to label (3) Start and run engine until it stalls. longer run. (5) Turn ignition key to OFF position. CAUTION: Steps 1, 2, 3 and 4 must be performed to (6) Unplug connector from any fuel injector. clips (18 gauge or smaller) to either injector terminal. (8) Connect other end of jumper wire to positive side of battery. (9) Connect one end of a second jumper wire to remaining injector terminal. CAUTION: Powering an injector for more than a few TERMINAL LEGEND NUMBER IDENTIFICATION 30 COMMON FEED 85 COIL GROUND 86 COIL BATTERY 87 NORMALLY OPEN 87A NORMALLY CLOSED Fig. 14 Type–1 Relay TERMINAL LEGEND NUMBER IDENTIFICATION 30 COMMON FEED 85 COIL GROUND 86 COIL BATTERY 87 NORMALLY OPEN 87A NORMALLY CLOSED Fig. 15 Type–2 Relay TERMINAL LEGEND NUMBER IDENTIFICATION 1 COIL BATTERY 2 COIL GROUND 3 COMMON FEED 4 NORMALLY CLOSED 5 NORMALLY OPEN Fig. 16 Type–3 Relay 14 - 12 FUEL SYSTEM WJ DIAGNOSIS AND TESTING (Continued) |