|
|
2. Powertrain Control Module (PCM) connector, C99, Circuit
Pin
(+) pwm motor C99 - J2
(-) pwm motor
C99 - K2 Ground
C99 - G3 PCM feedback
C99 - C4 5volt supply
C99 - D1
3. 4. Disconnect the connector, C40. 5. Key on, engine off. 6. Measure the resistance between: C40, harness side Battery
Pin 03
Negative terminal
Is the resistance less than 0.5 ohms? -> Yes GO to Pinpoint Test G552276t3.
-> No Repair the high resistance circuit. For additional information, refer to the wiring diagrams. Clear any DTCs, test the system for normal operation. G552276t3 : CHECK THE POWER SUPPLY TO THE ROTARY ELECTRONIC 1. Measure the voltage between: C40, harness side Battery
Pin 05
Negative terminal
Is the voltage between 4.5 volts and 5 volts? |