Jaguar XJ (X350). Manual - part 1518

 

  Index      Jaguar     Jaguar XJ (X350) - service repair manual 2003-2009 year

 

Search            

 

 

 

 

 

 

 

 

 

Content   ..  1516  1517  1518  1519   ..

 

 

Jaguar XJ (X350). Manual - part 1518

 

 

 

press the headlamp convenience button three times with in three seconds to activate 
the panic alarm, to deactivate the panic alarm insert a valid ignition key into the 
ignition lock and turn to the 'ON' position  

Double Locking 

Double locking prevents the interior door handles from unlocking the doors. 
 
Double locking is activated by turning the key, using the driver door lock cylinder to the 
unlock position and then to the lock position within three seconds or by pressing the lock 
button twice within three seconds on the remote transmitter. 
 
Successful double locking is indicated by the turn signals flashing twice, one short flash 
followed by a long flash and a chirp (if enabled). 
 
Double locking will be inhibited if the REM or FEM senses the hood, a door or the luggage 
compartment is ajar or open. The REM/FEM receives its input from the door ajar switches. 
 
If the vehicle battery becomes discharged after the double locking or central locking has been 
activated, opening the driver door with the key will mechanically deactivate the double 
locking on the driver door only. 

Master Lock Switch 

NOTE:  

  

Operating the locks more than 15 times in 20 seconds will cause the central locking to be 
inhibited for 20 seconds. If the locks are required to be operated in the 20 second waiting 
period they can be operated individually.  

 
The master lock switch will only operate the central locking if the ignition key is in the 
'accessory' or 'on' positions. If any door is open and the master lock switch is pressed to 
centrally lock the vehicle, no doors will lock. If the hood or luggage compartment lid is open 
and the master lock switch is pressed to centrally lock the vehicle all doors will lock.  

Glove Compartment Lid 

The glove compartment lid has no release handle. It is opened automatically when the release 
switch is operated. The release switch is located in the instrument panel between the glove 
compartment lid and the floor console. 
 
The glove compartment lid latch is released by a 12 volt electric motor which is operated by 
the glove compartment lid release switch. 
 
The glove compartment lid cannot be opened when the following occurs: 

 

the vehicle is being driven using the green valet key and the vehicle is in the valet 
mode  

 

the vehicle is centrally or double locked  

 

the vehicle is locked with the front door lock cylinder, when in the valet mode  

The glove compartment lid opening will also be inhibited if: 

 

the ignition key has been removed from the ignition lock for 40 minutes and the driver 
door has not been opened or closed  

 

the ignition key has been removed from the ignition lock for 30 minutes and the drive 
door has been opened and closed  

 

 

www.

Diagnosis and testing

 

 

Locks, Latches and Entry Systems   

Inspection and Verification 

1 . Verify the customer concern.  
 
2 . Visually inspect for obvious signs of mechanical or electrical damage.  

Visual Inspection Chart 

Mechanical  

Electrical  

 

Misaligned door(s), hood or luggage 
compartment lid  

 

Door latch(es)  

 

Actuating rod(s)  

 

Exterior door handle(s)  

 

Interior door handle(s)  

 

Door lock cylinder  

 

Cable(s)  

 

Luggage compartment lid exterior release 
switch  

 

Fuse(s)  

 

Wiring harness  

 

Electrical connector(s)  

 

Door lock actuator(s)  

 

Remote transmitter batteries  

 

Vehicle battery  

 

Remote transmitter  

 

Door lock switch(es)  

 

Front electronic module 
(FEM)  

 
1 . If an obvious cause for an observed or reported concern is found, correct the cause (if 
possible) before proceeding to the next step.  
 
2 . If the cause is not visually evident, verify the symptom and refer to the Jaguar Approved 
Diagnostic System. 

 

 

Removal and installation

 

 

Exterior Door Handle (76.58.07)   

Removal  

 

1 . Remove the interior front door trim panel. <<501-05>> 

 

 

2 . Detach the door wiring harness.  

 

 

 

3 . Disconnect the electrical connectors.  

 

 

 

4 . Detach the door wiring harness grommet. 

 

 

 

5 . Remove the door inner weathershield. 

www.

 

 

 

 

 

 

 

Content   ..  1516  1517  1518  1519   ..