|
|
Content .. 1335 1336 1337 1338 ..
Amp
box
32
5 Amp
Parking aid module, voice, cellular phone module
Primary junction box
03
5 Amp
Left-hand/Right-hand HID headlight,
Primary junction box
33
5 Amp
J-Gate module, transmission control module
Primary junction box
04
5 Amp
Instrument cluster
Primary junction box
19
5 Amp
Rear electronic module, engine control module
Primary junction box
17
5 Amp
ABS module
Primary junction box
4 . Where the Jaguar approved diagnostic system is available, complete the S93 report before clearing any or all fault codes from the vehicle.
NOTE:
If a DTC cannot be cleared, then there is a permanent fault present that flags again as soon as it is cleared (the exception to this is P1260, which will only clear following an ignition OFF, wait one minute, ignition ON cycle after rectification).
5 . If the cause is not visually evident and the Jaguar approved diagnostic system is not available, use a scan tool to retrieve the fault codes before proceeding to the diagnostic trouble code (DTC) index chart, or the symptom chart if no DTCs are set.
6 . Using the Jaguar approved diagnostic system where available, and a scan tool where not, check the freeze frame data for information on the conditions applicable when the fault was flagged. The format of this will vary, depending on the tool used, but can provide information useful to the technician in diagnosing the fault. CAUTION: Diagnosis by substitution from a donor vehicle is NOT acceptable. Each vehicle is configured to it's own VID block, and substitution of control modules may not only not confirm a fault, but may cause faults in the vehicle being tested and/or the donor vehicle.
|