|
|
Content .. 1261 1262 1263 1264 ..
Located above the message center are two lamps, red for warning and amber for caution. When a message is displayed, the appropriate lamp will illuminate to attract the drivers attention and to signify the importance of the message. Trip Computer Pressing the trip computer cycle switch displays trip data on the message center. Warning and information messages have priority over trip data. If a driver information message is displayed prior to activation of the trip computer, the trip data will appear for 10 seconds only, before being replaced by the original message.
Each successive press of the trip switch causes the computer to continually cycle through the stored data which is then displayed on the message center.
The trip computer switch pack, mounted on the instrument panel is only enabled while the trip computer output is displayed. Refer to the Drivers Handbook for full operating instructions. Message Center switch The message center switch operates the various functions of the message center.
The message center switch can be used to select trip memory A or B, switch the display between metric or imperial units or clear (hide) the displayed message.
Pressing the A/B switch and at the same time turning the ignition switch to position II will display the vehicle identification number. Pressing the ML/km switch and at the same time turning the ignition switch to position II will change the displayed language. Press the ML/km switch again to toggle the available languages. Press the A/B switch to select the desired language. Refer to the Drivers Handbook for full operating instructions. |